Viewing all customer Discussions for:

Drawer & Cabinet

Hi, i need to replace this hinge and I can't figure out what to use to replace it? The only identifying marks on it are DTC. Thank you, Courtney

I want to know if you have this piece

Looking for some replacement plastic side guides for my kitchen drawers. A few have dry rotted and become brittle. Any suggestions would be helpful. Thank you

Need set both right and left

it shows ACME 4012 with roller 4011 on the parts what is your parts replacement number and is there a distributor in BC Canada?

Number on part A6839DC

trying to find more drawer guides or a replacement.

I'm looking for the air dampener part for the Grass Elite Plus 19 undermount slide. The slide part number is 7523-19/550/533, the dampener has "28.02.07 AVS421 1L08C04" on it, but I can't find it anywhere. Thanks!

Hello, We have these older hinges in our house that we want to update. The issue we have is the part that screws onto the back of the cabinent is not long enough on ones we find in Home Depot and such. Can you please recommend a replacement in the silver satin finish?

Looking for a hinge as attached. It has a marking on it of KD80FL. It's been on the cabinets since the early 80's. Hope you can help! Thank youPat

These are side mounted on old 4 drawer cabinets. There's a side channel on the drawer that slides along this guide.

6 ft chest has bottom 3 drawers that come open after they are closed. They are not overfilled. What is needed to stop this?

Dear Swisco, Can you help me find replacements for this type USIP hinge? I need quite a number of these for apartments we manage. Thank you, Kathleen

Labeled Century, I have a picture but the website won't let me upload.

Good Morning! I need a replacement for my rear drawer track. Based on the photos is product 32-012 Correct? Best, Tim

The original hinge (photos provided) are Mepla: hinge part no is 502.205.76.03, plate part no is 592.393.85.00. In the interim I am using hinges that do not allow door to open fully. When closed, the door sits at a 135 degree angle. When opened, the door stops at 200 degrees (see photo); being bl ... (cont.)

This hinge is from a Robinson Hutch door made here in Wilson Michigan bought in th mid 90's. They are self closing and all need to be replaced. The plastic spring holder has broke on them. Not sure the style or measurements. including photo's. No help at all from the company that makes the hutch. ... (cont.)

Hello: The above is off a bathroom cabinet, the left hand side. Markings show "643." I cannot find a replacement bracket anywhere. Thank you in advance for your assistance.

For a dresser drawer slider

Back to front 3 5/8" Opening 1 1/4" outside 1 1/8" inside x 5 /8" outside 3/8" inside