Viewing all customer Discussions for:

Drawer & Cabinet

The cabinet hinge has the name astrocraft, I need about 4 of these please send me the part number

This is part of a under drawer sliding hinge. This part I needs locks in the actual sliding hinge

Hi ,Looking to get a few of these screws which are from the kitchen cabinet bracket shown in the second picture.The bracket picture seems to have different screws than those I show in the other picture which are the screws in most of the bracketsIf you have the bracket only I would consider that al ... (cont.)

Searching for cam lock nuts for large cabinet at 1 inch in diameter. Am searching for 1 inch hard plastic Cam Lock Fastener. Furnature purchased in Germany. So far, have only found 1/2 inch metal Cam Lock Fastener.

Hello! Could you help me identify a replacement part for this bracket? It says Ferrari on it, and 710M. Let me know if there's anything else i can describe.

Would your 32-119 part replace this? The measurements look good. Thanks I?m glad to find your site!

The attached photos show the part that goes inside the dresser drawer track (One on each side of drawer) that guides the drawer in. There are no markings. You do carry the middle glide part; Kenlin case runner. I?m buying a dozen of those and need these side pieces to Go with. Thanks so much! Ter ... (cont.)

The picture on the right is my actual track. I have three drawers that the plastic mounting is broken. The picture on the left I found while googling. Hoping you can help me. Correction, picture on the left is my actual drawer with the plastic mounting. The picture on the right is from your site. I ... (cont.)

hi, these are side drawer guides from a dresser. they are nylon and i can send one to you if needed. the pictures should tell you what to get. thanks neil

A few of our dresser rail supports have broken because they are plastic. We would like to replace them

part number 471029It is approx. 2" x 1"Part number 471029 (don't know what brand)

Hinge has markings that look like an N logo. Along with patent #3212124.I traced the patent back to Robert D. MacDonald for the Bildwell Company - 1964.Started this project trying to figure out how to adjust the hinge because a few of my doors wont stay shut. Is it possible to adjust them? Or do ... (cont.)

These are for wooden center tracks for a dresser

Cannot find this hardware anywhere. Unique thing is that bottom slide bends at 90 degree angle to fit into rear plastic support. House was built in 50. I cant even find a picture online of this. Bottom slide is 23 in long and top slide (connects to drawer) is 21 3/4 in. The wheels on all of the ... (cont.)

Drawer glide for Vaughn Bassett dresser

I need help finding a replacement part for my old drawer. It broke again. I had to have the drawer rebuilt too, so it is heavier than it was. The bracket was already broke we glued it but its broke again. The pictures are from the other side.

This part goes in the back of my cabinet and holds the track to my kitchen drawer. I have one center track.

Please assist

Hi, The right side (the brown one) bracket (32-012) is broken on one of our kitchen drawers. I have already purchased the new bracket from you. However, I cannot seem to locate the fasteners/screws that has mounted the old bracket to the back of our kitchen cabinet. Therefore, I cannot take the ... (cont.)

I'm looking to replace these with a brushed nickel finish. Im not able to find anything with the same dimensions.