Viewing all customer Discussions for:

Drawer & Cabinet

Do you stock Haas cabinet slide guide #4930739? Please let me know. Thank you.

I have a broken bail pull that goes on a Thomasville nightstand #40611 cut #16-188 code #0401. I need a replacement

The corner cabinet hinge broke in two. Is there a replacement. Thank you for your help. See picture.

Hello, I have Merillat cabinets and the rear plastic support brackets are failing on several of the slideouts, it is my understanding that Merillat no longer makes the bracket so I am hoping you could help with an alternative. The slides on the cabinets are in good working order so i only need the b ... (cont.)

Do you have a replacement for this cabinet spring hinge?

Do you have one that is a 1/4 inch wider for where the shelfing bar is slid in and being held in the plastic sleeve?

We cannot find any identifying markings on this, but it goes on a large deep bureau drawer. The dimensions are W 2 1/2" by H 1 15/16". Thickness is 1/2". Can you help us with this part? Thank You Fred

Do you think there is a newer model for the following hinge (serial number 651.000.34.00), or do we need to get new cabinets?

Do you have a round flat 1/16" thick tack guide? Like the 32-117 only thinner?

I am looking for replacement hinges for an antique Scheirich cabinet. I am attaching pictures. Please let me know if you can help me. Thanks! Elizabeth

Builder grade kitchen drawer cabinet side glider. Only identification G. LC See attached photos

# 32018 what is the length

this is for a corner cabinet( L shape with 2 doors ) has 2 sets of numbers on hinge 244.3653 01 4 and other numbers 1526. total length 5 1/2 in.

Hinge made for homecrest cabintry by mepla before 1985 will 32/340 work for me the men frome NJ. ON APRIL 17 2015 FROME Lincoln Park NJ. IS the same Hinge

have 5 drawer chest 18w x 18d x 54h #115. was told a clip broke under drawer as drawer falls slightly when opened. can you help identify what is needed to fix this problem by what I described and what the cost would be for part?

I am looking for multiple pairs of rear mount drawer slide sockets. The overall length is 3 7/8

2" wide at widest point, 1-5/16 inches tall - slot opening is 13/16 X 5/16 - this is for a maple dresser that is 25 years old (I believe it is made in the US) Thanks!

Purchased a condo that has drawers, circa 1985, several of the rollers are missing. Eventually they will be replaced but not now. Cannot find them here in Las Vegas. They attach to the back where the sides are longer than the back. they are left and right and have an L shaped mount. The larger part ... (cont.)

Seeking a hidden 170 degree cabinet hinge about 5" fully extended . The cabinet door weighs about five pounds.

Help! My 1976 kitchen drawers are not broken, but the ones I use the most are sagging. The drawers I use the least are not sagging. How can I fix this problem? Thanks.