Viewing all customer Discussions for:

Drawer & Cabinet

Do the 32 335 hinges have soft close, or is a damper available? I am using these on steel cabinet doors where the 35mm bore is not possible. Thanks!

I am searching for a match to this 3 1/2" Thomasville brass drawer pull that is attached to a set I purchased in 1992. i am looking for 10 of these.

I need to replace several plastic drawer glides that are on my parent's very old cabinets. The current plastic glides say Hardware Designers Inc, So Hack, NJ USA. I did not think to measure the width of the metal glide rail, and the plastic glide is broken. opening on the plastic glide is about 1 ... (cont.)

This is for a stove drawer. It has rivet type but I would prefer to replace with a bolt style.

Hi. I have bedroom furniture ( Vaughan- Bassett) and I am in need of some drawer guides. item # 820-002-401. M20-Runners/Guides split . My furniture has been discontinued by the manufacturer and I was wondering if you could find some guides that are adaptable. I would like to order a dozen if y ... (cont.)

Are the holes 2 inches apart (center to Center) 32-345 product?

You had offered another bracket in this link: Larger shelf bracket needed : SWISCO.com discussions/Larger-shelf-bracket-needed-77-63347 I received my order today of (12) 32-313 : Shelf Brackets, but unfortunately, I did not order the right item. but I think I am going to end up with the same ... (cont.)

Hello, I have some cabinet drawers that need replacement wheels. The cabinet maker is St. Charles and it was installed in 1964. The following are 2 photo of both sides of the wheel. They measure 1 inch. Thank you for your assistance, please let me know if you have any questions.

8m810. 02.01. 78-850-0101 numbers stamped on 175L660-01.22

The 32-080 rear drawer bracket if I order 5 is that 5 pair or just 5 items? I need 5 pairs of rear drawer brackets. The part of the bracket that holds the rail has to be 7/8 inches high and 7/16 inches wide on the top and bottom of the bracket. I would like one that is longer than the 32-080. ... (cont.)

2 1/2 in centers looks identical to elements wp150-ab

hinge is from Kemper cabinet on back of hinge I have Austria 110 34.355-01.01 overlay is 1 3/8"

I need a bracket like this that is about 1inch deep. The pocket depth of this one is almost .75 inches I need one a little deeper.

Hi, I was wondering if you could help me out? I need the exact part as 32-041 but i need a wheel that is 1 inch. Would you be able to help me out with this? Plz let me know. thx John S.

The rollers are plastic. 1 1/8" across and 1/4" thick. Need several. Any help you can offer would be appreciated.

How thick is the 3/4" curved part? How think is the 1/2" section?

need replacements

I have Merillat cabinets built between 1988-1989. The track socket is plastic and it has broken in two of my cabinets. The piece is still mounted to the back but the side piece of it that the rail slides in has snapped off.

looking for 3 handles as shown in picture handle is approx 3 3/4" long

Attached are 3 pics of what I need. It is a Grant 336 CL. 20" track length. The ball bearing wheel is pressed into the frame so I'm figuring I will have to replace the entire track as well. Let me know what you recommend for a replacement since I can't find the exact match anywhere. Thanks, ... (cont.)