Viewing all customer Discussions for:

Drawer & Cabinet

I need these small items

Hello -- I found that someone at Swisco helped another customer after a picture was submitted of the plastic kitchen cabinet clip that was needed. Checked all your images, but could not find the one I'm looking for. Could you help me? It is about 2 1/8 inches long; holds a 1/2" shelf; has an 1/ ... (cont.)

Hi, I have a Pennsylvania house hutch purchased in 1995 and I love it. Unfortunately, the drawer guide is now broken. The marking are 40-28. Pat #3.201.187. I believe your 32-118 is the replacement. My question is how do I attached the guide to the drawer? Do I need a special staple gun? When ... (cont.)

Please help me find this hinge

I can barely read on the rail itself that this is a Grass 6600 system. I couldn't find on line a rear rail holder that had the dowels on them. If they are available that is what I need. If not I can use a screw in bracket, but I want to make sure I get the right size. I'm going to get 2 right and 2 ... (cont.)

Overall length is 22 5/8". Overall width (top to bottom) is 1". Rail is for a glide roller mounted on the center of the drawer. The rear support would be your part, "Rear Drawer Track Socket Product Code: 32-001" (I think). thanks for the help!Robert

Looking for rear center socket to fit single monorail. Dimension of rail is approx is 22 inches long. Depth 7/8 and with width approx. 7/16th. Thanks Don

1 1/16 bearing with Teflon at OD.

Plastic Drawer Guide by Ronthor Relss Corp, NYC Item # R-40-26

Directions for installing case runner 32-076 and 32 082. This is for the drawers in a dresser made by Stanley furniture co. We have to replace 3 of the first and 2 of the second. I want to be sure we can do this ourselves. Thank you

I tried a bracket that looked close, but the bearing that runs in the slide was slightly too small. Any suggestions? Outside dimensions are approx. 1 3/4" H X 3" W outside, 5/16" H X ! 3/16" W bearing. Thx

Hi tim The part is approximately 1 3/8

I need a replacement for a rear mounting socket. It is 2" tall 4.5" long. It accommodates a slide that is 7/8" x 3/8"

It is a drawer part mounted to the front of the drawer and serves as catch to keep drawer in cabinet. The mounted edge is 1 and 3/4 inch. The other square edge is 2 inches and the pointed edge is 3.5 inches to the point.

Hello. I am looking for two replacement kitchen cabinet latches and I am unable to find them anywhere. Please see attached pics and advise if you carry these, or if you know where I can find them. I bought my home in 2008 and have no idea where these cabinets came from. Please advise Thank You ... (cont.)

Hard plastic, back bracket to secure hardware, at least 20 years old, Broken part is on the left side however looking for both sides

Hello, Would you know if these are still available. I think they were for Schrock brand drawer glides?

Post D92: I wanted to add that my metal tracts are just open channels(U shaped) and not like the white tract you show with a stop screwed on it. Im worried if I buy the Kenlin socket and stop I wont know how to install it and make it work correctly. My socket and stop are the numbers I gave in my fi ... (cont.)

Hello, I am looking for a back plate(?) that holds the slides. Let me know if you have the part and the cost. I could not find any part number on it. Thanks, Vivek

This hinge/hardware is for a medicine cabinet door. The door opens from right to left. The second image shown is the hinge as it is installed. The difference being that this medicine cabinet cabinet opens from left to right.