Viewing all customer Discussions for:

Drawer & Cabinet

It is a bout 4in a half inches long to lineup the holes should be 2 inches apart we live in Santa Rosa California tell me where we could buy am at anywhere close to here and not tell me if you have a on stock thank you

Looking for replacements for a desk which i was told is obsolete. Let me know what you have that can work. 15/16" and 3/8" center hole.

I am sending pictures of broken plastic piece that is part of drawer system. The piece is screwed to the back wall of srawer and provides support for slide on bottom of drawer attaches drawer to cabinet

Please help to identify the two parts attached. Both were used for Kitchenmaid cabinetry installed in 1992. One part piece was used for a rollout drawer,piece stamped with 471029. Two piece part was used for larger drawer and stamped with 3809.

Have a two inch wide drawer slide. Need a socket. Plastic one currently is broken, they are side sockets.

I need a replacement for this hinge. Two of them attach to the cabinet door and one is broken. A number indicated behind the hinge is 198.660

Hello, I need to find a replacement part. The part attaches a slider draw/tray to the inside, side, of one of my Kraft Maid kitchen cabinets. The part was manufactured by Mepla and the part number is 600.010.09.25. I have attached some pictures, one includes some dimensions. The material is some ... (cont.)

We are trying to find the company that made this hinge so we can order another two, as this one is broken. Under the hinge it says it was Made in Germany. It lists numbers 699.265 on the underside along with numbers 53.20 below it. On the other end of the hinge it also lists the numbers 346.290 ... (cont.)

I am trying to match these guides

The part has no markings. It's entirely made of plastic.

I am trying to fix the drawers of a dresser, made by Dixie. The name of the line is Windjammer. It looks similar to 32-053 on your Website; however, the one I am trying to find is about 14.5 or 15 inches long. Any suggestions? Thank you!

I am looking for a pair and if they fit another 9 pair of scherich drawer guide boots for my kitchen cabinet drawers that were installed in 1986...I received some from Roc that gap was to small for my slides . I just want to make sure the slide is at least 1 inch to allow my slide to fit. so you h ... (cont.)

Greetings Swisco! I have been looking for a particular type of shelf support for a couple of years. Bainbridge Manufacturing actually referred me to you. I have not been able to locate exactly what I

How much distance is their between the screw openings on the right side of the hinge or part that fastens to the cabinet for hinge # 32-343? Please advise

The part sits in the front corner of the drawer area and acts as a guide for the drawer. It is about 1.5" long.

We do not have a brand name for this hinge. The metal connector is broken so the whole hinge has to be replaced. Can you please advise if you have a recommended replacement hinge in your inventory.

See photo attached I need a replacement part for this! MBH

Hinge was installed in a kitchen renovation in the mid 90's. Any help in locating a replacement would be appreciated. Thanks, Jack

Hi! No luck in big box nor smaller hardware/furniture/appliance stores. This one is off the back of a kitchen drawer. It has a single center guide on top as opposed to two on the sides plus some sort of wheel (think Ikea). The part is without any markings, stamps or numbers. It is 2 1/2" wide by 1 ... (cont.)

Our Kitchen has 14 drawers with Swisco drawer slides and brackets (PN 6600). See attached photo. 6 of the drawers have broken rear brackets. How can I get them replaced? Thanks, Mike