Viewing all customer Discussions for:

Drawer & Cabinet

We need 2 of these drawer slider spacer.

For the Self-Close 3/8" Inset Hinge Kit (code 32-127), I need to know where the 3 holes on the door side of the hinge are located, exactly. Can you supply that?

Do you still make these. If so I need a dozen or more. The plastic piece that goes on the bottom of the drawer is what I need

They are 4 1/2 inches installed (both pieces) These are only 7 years old ... but we can't find them at Lowes or Ace Hardware. Do you have these? Thank you! Bee

I need a new latch but cannot find one

Home remodeling

I also am needing three Irex cabinet hinges (stamped 0702). ANY help would be greatly appreciated--the middle mirrored door of my medicine cabinet was removed when the hinges were damaged by a service person who pulled on the door. We had to remove the door, and would like to re-install it.NOTE: Th ... (cont.)

I'm looking to replace these cabinet hinges in black. Any assistance will be appreciated! Karen

Hi,can you please help me find this part?

How much for replacement hinges? Thanks!

Do have these hinges

I'm looking for drawer slides. Thanks!

Hello,I have a customer who needs replacement shelf clips for the attached.The print reads Jawala Int No.132.The customer just needs something with the correct DEPTH of pin to fit in the existing holes.It does not necessarily need to be a locking clip type support; it could be a straight pin or angl ... (cont.)

Hi! I am looking to replace the rear mounting brackets (left and right) for my old Merillat cabinets (installed in the 90's) The part was discountinued by Merillat in the early 2000's and I purchased everything that they had left, but I'm now out. I looked at another message from a customer who a ... (cont.)

Looking for multiple replacements of these items. Both left and right side.

1 13/16 wide x 1 5/8 high with screw holes 1 5/16 on center and 13/16 from bottom. Socket is 9/16w x 15/16 h x1/2 deep

I am trying to find a replacement drawer 2-screw pull for my friend's vintage Drexel China Cabinet (it was her Grandparents'). The hutch stamp is No. 7000-4 MAH by Drexel. I have seen the small single screw pulls online & they are referred to as Drexel Autumntone pulls for dresser or nightstand. The ... (cont.)

Clips to mount faux drawers panels to cabinet front

I need hinge sets for different doors in my home. I think I have an idea of the line cabinet hinges, but I need help on the corner cabinet. One of these sets is a bifold door on a corner cabinet w lazy Susan.

Hello, I need replacement for old Mepla lazy Suzan pie cut corner cabinet. This part is discontinued pls assist.