Viewing all customer Discussions for:

Drawer & Cabinet

No markings

Frrrari hide with 1 1/4 overlay

checking..

Looking to find this part to replace for this broken one for my big kitchen drawer. Thanks.

I need a bottom mount drawer slide for a Thomasville dresser. The part that attaches to the bottom of the drawer about is 15"long and the part that attaches to the dresser is about 16" long. It has a small slide with four ball bearings.

Looking for the hardware that match these items. The slide on the drawer itself measures just over 22 3/8 inches. The slides that are attached to cabinets measure just under 23 inches. Also need the same hardware with measurements of 19 1/2 inches on the drawer and just over 20 inches on the cabine ... (cont.)

Hi I'm looking for a replacement drop bail 6 inch draw pull. Got a number of decorative hardware in picture. I think it reads k 4956. N kBC 1It's a Thomasville dresser I believe 1964

Has a plastic back mount that adjusts.Rear plastic mount is broken. I would like to buy an extra set and plastic mount. If theres a metal rear mount that I can use I would prefer that. I was looking to see if there was a brand name anything. They were mounted with new Kolville cabinets approx 5 year ... (cont.)

I am trying to find replacement drawer guides

This is the part I need, check order number 2037263

Hello, I'm looking to match this bracket that holds up my sliding cabinet drawers.

Hinge on kitchen cabinet.

need to hinges for medicine cabinet/keystone

old school olde-rite.pat .mfr332201 17 1/2" bottom mount drawer guide. need 21 1/4" length .These guides were made by ken enterprise incorporated highland park Illinois.

Looking for attached part

Hello, Looking for this part maybe built between 200 and 2010 cabinets were from quality.

I'm trying to find any sort of replacement for this Mepla hinge that has 510.356.00.11 on the base and 698.256.50.00. Thanks, -Guy

Looking for a spacer for a pull out cabinet drawer. Needs to be strong as drawer holds approx. 25 lbs. The drawer slider brand appears to be Mepla (Made in Austria).

Part marked 1A. Sslj08r

I have a broken cabinet hinge that is 20+ years old. The information on the original hinge is as follows: stamped MEPLA. Made in West Germany. Numbers on cup that mounts into the cabinet door: 698.254 53.00 numbers on hinge part that attaches door to to cabinet frame 348.253 99.79 Numbers where h ... (cont.)