Viewing all customer Discussions for:

Lavatory

This requires holes in glass?

i have sterling 5000 shower series two panel tub shower door. I need part number 517101 which is the clear guide for the shower door. they no longer make it. do you have one that would fit this door? Thanks

Need at least 2 (4 would be better) dual purpose screws after the heads came off of 2 of them. This is for the 10-216 glide replacement. Thanks!

My roller wheel is broken,on the glass, I can see:ANSI Z97.1-1984. N.K.G

Do you carry the rubber gasket that would fit into the this aluminum drip rail.

I no longer have the part. I hope that from the pictures someone can identify the part.

Hi, Could you tell me what the width is of your part 10-004 "Top Plastic Guide" Thank you!

House built in 1992. Sliding glass shower doors with plastic rollers on top and lower plastic guides engaging groove track. In need of lower plastic guides because engaging tip has broken. With broken guide, door can swing off upper track.

This is door that needs 2 inch hole spaced door handle and towel bar to hang on the outside of the door. The measurements for both items are in the attached pictures.

I think this part is Swisco's 10-153. Which is perfect EXCEPT the post inside the glass holder is isn't deep enough.. the 10-153 post is about 1/2'" from the top of the the glass holder. The center of the hole in my shower door glass is 3/4". o you have this part? If not do you have anything else ... (cont.)

Can you tell me if this seal is bigger than 3/32. The one I bought to replace the seal 3/32 is to small?

Any thoughts or ideas on replacement parts for these? Looking down into a recessed area behind the rollers swivel-arm attaching screw, there is either a "4" or a "2" imprinted on the part. that's the only identifying numbers I have found.

Looking for Old sliding shower door bottom guide

The roller pictured is from a King curved glass shower door. Looking for a replacement. Thank you, Christina

Hello, I have a 2018 Winnebago Spirit Motorhome with a curved shower door. One of the top rollers has broken. From the attached pictures of a good roller can you tell me which roller I should order to replace the broken one. If there is any more information I can provide, let me know. ... (cont.)

Hello, I am searching for this thing (see picture) and it happens to look a lot like the one pictured on this site. I was hoping someone would know the maker or possibly give me some good leads if nothing else. Thank you so much.

I can't seem to locate the manufacturer any more. The vendor # on the parts was W1191 and the manufacturer's number was 420040 when we replaced these parts in 2004.

3-12" shower door handle From the outside right of the shower door

Replacement part for the back of the metal handle bar on shower door

My hinge broke. Looks like it eroded over time (We have hard limestone water) Top hinge is perfect -stays dryYour pivot hinge looks like it would work. ??Cant find one anywhere else!! No markings on door or frameBut I'm pretty sure it is a Maxx Madono. Help appreciated. Mary