Viewing all customer Discussions for:

Lavatory

Shower is made by Aqua Glass. The original rubber strip was replaced by a local worker who got it at a local company and not the original part. This part went bad and was not really suitable. Hope this helps you. I know it is not very definitive on our part. Thank you Jim

I just received my shower door rollers for my Manhattan corner angle shower enclosure but realized I don't know how to put the rollers on the track. Each side panel has two screws at the top of them, do I remove those screws and then pull out the top track? I don't want to damage my enclosure and mi ... (cont.)

Trying to identify and buy the rubber part that goes in this assembly

This is from a curved shower door, attaches to the bottom of the glass to guide the door as it opens/closes. Wondering if anyone knows where I might find one to replace. Any help would be appreciated.

My rolling shower door has a roller at the top and a guide at the bottom. Do you have this piece? See the attached photos.

Is the 24 inch the smallest length?

Does the shower sweep come in 44 inch width? Thanks

Hi, What is the easiest way to remove and replace broken retainers? Is there a guide or installation instruction? Thx. P.

Koehler inside shower door bottom that holds the door 27? 16cfr-1201II Soccer-1979 1/8ua 111810 164125

Is it possible to purchase the "bumper" parts for the Delta Simplicity Semi Frameless Sliding Bath Door? 60" x 58 1/8". I refer to the 2 small "gripper" parts that hold the door glass open or shut Mine have lost their "grip". Is there a kit available that includes these plastic/rubber parts? ... (cont.)

Hello, my shower doors are American Standard...will the 10-058 kit work? Thank you

This is a three door sliding door shower, the long piece its about 2 inches long and goes inside the bottom door, its completely inside the door held by a screw on {the picture} and the hook or what hooks on the frame like a ninety degrees hook, goes in the Side bottom track.

Hello, I am replacing parts to my rounded shower doors. I have been unable to find two of those parts. I can only attach pictures of one part at a time so I will attach the magnetic part in this mailing. The tracks for the magnetic strips are approximately 70" long. I will need two pieces. I ... (cont.)

There are no markings anywhere in shower to identify it. It's original probably mid 90s. I'm looking for a replacement for this drain rail. I don't think it ever had a plastic or rubber sweep.

Pwhich screws would I need to purchase for the 10-138. I also hope it?s the best match for thenN.A.8141. Thanks for your help in advance ellen tyrnauer

I'm looking for that partition slide latch or something that will work

Steering/Kohler Company advises they have discontinued carrying Panel Guides part number 517101 when ordering them last week. The existing panel guides are 1 1/4 inches long, 1 9/16 wide, door slots 1/2 in wide and middle spacer 5/8 inch high from the door rail to the top of the divider and 1/8 inch ... (cont.)

Hi, There are no names, marks or anything on these parts or the enclosure, hmmm? Though the glass has 1984 stamped on it . . . Please let me know if you can help. Charles

Hello, I have a Unitex Tempered shower door and I am trying to find a replacement for the black bumper pictured. I think the shower door is a CPSC16 model. Other etching on the door are CFR 1201-11 and ANSI Z97-1-1984. Have you got this part?

I am looking for this part of my shower that broke