Viewing all customer Discussions for:

Lavatory

I have a 23 1/2 inch rail that needs replacing on my shower can you tell me which one is a better fit thank you

My old shower door sweep is about 21.5 inches long, two screws. Please see attached photos. Is this product a good match? If not, please recommend one. Thank you!

Need replacement. Gasket as square groove

The top roller broke for this shower door glass

The glass door is 1/4" thick and 66 3/4' tall: This needs a flap to seal the water from coming out of the shower. The door frame has a 1/4" T shaped slot that the previous sealer was contained. The pictures of the door sweep shows 3 screws that locks in the sweep bar. I sent you a copy of the h ... (cont.)

What are the dimensions of this bumper tip replacement? Inside circumference and length please.

10-593, Bottom Hinge Bracket - Can I purchase just the 2 plastic parts of this assembly? my metal brackets are fine.

What is the correct part number for the replacement part for the roller shown in the attached picture

botom glass door frame that joins the longer frame metal part secured by a screw is not screwing into female end because it is either stripped or partially broken. what do you suggest. parts [ sliding guides did fit well. Replace metal part ? Strip measures 223/4" long and 13/4" wide. or is there a ... (cont.)

Thanks for your help. Here are 2 photos of what I now have. John R

Shower profile is attached. Length is 29 inches and is on the bottom of a framed hinged door. Thanks

What is this piece called? Runs vertical the height of the shower door.

Hi, I have what looks like a "home made" shower door and need to find a way to prevent water from leaking over the threshold. Is you door sweep the right solution for my needs?

I have a shower door that recently got stuck while opening and came off the track. I think it may need changing of the rollers and guide parts. I am not sure of the parts hence attaching the pics. Please help me with the parts and steps to replace them. Gaurav P

I just installed the 10-325 shower sweep with drip rail and noticed that on the left end (NOT the side closest to the actual shower but the side that actually swings out when the door is open) the metal could potentially be a hazard if one were to hit it hard. Do you suggest putting some kind ... (cont.)

I think Part 10-137 can replace my shower slider - but I do not know how to take the old shower slider off and replace with Part 10-137. I need help. Attached is my shower slider - the round part is missing Linda

I'm looking at the 1/2 inch frameless shower door sweep with a drip edge, what is the best way to cut the length?

I'm looking for a replacement weatherstrip insert for my Pella door. Its ID# is 90563.332, which I believe is a model 332.

I see two guides that need to be replaced. My question is am I missing any? How many should I get total for a full replacements on 2 shower doors?

The bolts that screw into the towel rack brackets broke and the towel rack does not stay attached to the door.