Viewing all customer Discussions for:

Lavatory

The wheel to the shower rusted off. What would you recommend for this? I see the double, but do you have a single? Thanks!

Hi, I am looking for this part only please help. Thanks.

Single shower door clear door seal ,but mounted on the door framework at base

Hi, I'm looking for a replacement part for Manhattan shower door. I'm not sure of the name of the replacement part but it's a black color arc robber band sealant that runs the length of the base at the bottom of the sliding door. Please refer to the picture shown above. It's the circled black ro ... (cont.)

Hi, I've been looking for this bracket, for the glass door of my bathroom, I do not know if you can give me more information. Thank you

Here's what's on the door of the shower: King Glass Tempered Glass ANSI-Z97-1984 16-CFR-1201-C11 cAN/CGSB-12-1-m

My curved shower doors have a gap in the lower corner. It's an American Standard Ovation Series door. I'd like to lift up one corner by 1/8 or more. Is the 10-058 adjustable? Do you have any shower rollers that are adjustable?

Hi, My shower is a framed stall door. There is no seal on the bottom of the door itself. Instead it is in the frame. It appears to be a bulb and is mounted in a track. The only way I could get it out I believe would be to remove the frame. Even then I'm not sure I could find a replacement piece. ... (cont.)

Hello, I have a concealed door knob and latch that has a piece of the door latch broken (see images). I don't think there is another door latch i can use to replace current?? So i think i am stuck with #10-401 replacement kit. Please advise. ALSO, if i am stuck with kit# 10-401, how do i get ... (cont.)

Dreamline shower 1999 bottom door rail guide purchased at Lowes. In a previous post you said it may be your part 10-1039, but I can't find that part in your catalog. Plastic tab with a thicken bottom that fits in a grove in the bottom rail and keeps the door from swinging out.

I'm looking for parts to a maax corner stall w rounded door

I don't see any manufacture name on the shower door. It's roughly 30 years old. Attached are pix

Got a Pasco single shower stall with a swing out door. House was built in 1997. The lower door seal is bad and can't find one. Don't have a photo of the seal but have a shot of the stall. The white seal is a after market one I tried to make work.

I see that you carry the 10-134. that's the part on the bottom of the door in this photo I found. What is the "top part" opposite the bottom roller? The 5 white-ish guides with screws through them?

shower door frame is 27 1/4" wide, 3/8" thick bottom edge, metal strip is 26 1/4". This is a over 20 year old shower door. Rubber and hardware rotted and deteriorated due to very hard water. Attaching screws rusted out.

Hi, I have attached two photos of my door sweep. It would be great if you can recommend a replacement part. Thanks!

I am looking to replace this bottom shower glide. It attaches the lower part of the door to the frame of the tub. Can you please take a look at the photos to see if you have something compatible. Thanks, Jason C

Looking for new shower door sweep gasket - Which one that you sell would be the closest? It has a half moon top Thank you in advance

Assuming this product will work as a replacement for the plastic shower sweep currently installed? Can holes be drilled to match existing screw placement on the door. Picture attached Thank you.

This client shower door roller assemblies top amd bottom now longer work properly. I am not totally sure why except it drags badly when trying to roll it. To make sure i get it right i would like to order all nessesary parts that are used for panel rolling movement. I dont believe there is an ... (cont.)