Viewing all customer Discussions for:

Lavatory

How does it attach, is it screwed on or with an special adhesive tape?

I was wondering if you could tell me the diameter of the wheels in this kit please?

Gasket is missing. Do you have one? Looks like it screws behind the water shield. Should I just put a whole new replacement shield with gasket?

I need to replace an All American Metal Corp Knob Assembly i was wanting to know if the 10-556 and the 10-557 will work. I am installing them into a area where disabled people would be using it So would i have to use the 10-557 being its ADA compliant. Hope to hear back from you soon! Thanks! ... (cont.)

The first three mages were taken when the part was off and the last when it was on. photo.jpg and photo(1).jpg need to be rotated by 90 degree to become straight up.

Will this knob work as a replacement of an All American Metal Corp. knob?

The latch on my shower door, installed in 1985, is a rubber "ball" that clicks into a notch on the shower door frame. The ball and notch have both worn down and the ball won't stay in the notch. If I could just replace the rubber ball, I'd be fine. Otherwise, I'd like to find a handle assembly that ... (cont.)

The rail is not as wide as the door bottom, and I'd like to know how to position the rail (left to right) on the door? Also, do you have the replacement screw? There are three screws, pan head, phillips, sheet metal threading (pointed), look like galvanized steel. Length of screw is 5/16" total, ... (cont.)

My existing sweep has a two sided tape between the sweep and the shower doors where the screws go in. Is this necessary with the 10-325

I am going to order your 10-325. I will drill new holes for he installation. Can you give me some alighment information as to how high to mount over the shower. When installed how much bend is there in the sweep Bill H

Please help. I need a replacement for this part.

Your part 10-561 did not fit this latch mechanism. Will the 10-563?

I have a metal shower door sweep with metal drip rail with two screws for a hinged shower door. The sweep is 26-3/4" and the screws are about 2-3/4" from the ends. can you help me get a replacement part? I can't cut one myself. thank you.

What is the difference between 10-556 and 10-562?

First picture an end cut of the door sweep - it snaps into the bottom of the door - the sweep is 28 inches long. The identification tag on the upper tail says the door is a "Keystone 96235 - 17 - 70 Feb 22, 2001 W/O: N0032319" as in the 2nd picture. Any help would be appreciated. ... (cont.)

Can you buy just the washer that fits in this assembly? Also do you have the replacement assembly?

Hello, I purchased a Maax US Corp shower in 2008. The parts that hold the doors on the tracks (both uppers and lower pieces) have broken and need to be replaced. I went to Menards (where I purchased the shower) and they could not help me get the parts. Can you help identify the parts? If so, ... (cont.)

I am looking for a Shower Door Bottom Hook Guide replacement (see attached photos). The shower door is at least 20 yrs. old with no manufacturer markings. I recently ordered from you Item #10-139, Shower Door Bottom Hook Guide. The photo(s)on your website show the measurements of the item to be 1 1 ... (cont.)

Hi I was wondering if I can get a 10-324 in brass color But 30" long

I just got this part and they look like the correct part. Just curious if you know how they are installed. I tried sliding the broken glide out and it didn't budge. There is a screw at the bottom of the door (of course it won't unscrew for me) but wondering if I need to remove this screw prior to ... (cont.)