Viewing all customer Discussions for:

Lavatory

Can this latch be used with a solid 1" thick wood partition door? Do you have installation instructions available?

This bracket holds the wheel that allows the door to roll open and close. I am in need of the bracket and wheel. The one pictured is from the other side of the door. It is in working condition. I don't have any part numbers from the shower door nor to I see any manufacturer name on any parts ... (cont.)

Need the same exact model, but ADA compliant. Any ideas? thanks Dan GLOBAL Deer Park New York

Hi van u please tell me if u stock these type shower door rollers

I have a problem with my sweep. On the side that is hinged, I still get a water leak. I have something similar to 10-324 in design. Should I replace the whole thing or is there some other solution? Thank you.

I was hoping you could help me identify this latch. The disc measures 1-5/8

I ordered a 10-126 shower door handle to replace the broken one on my shower door but the holes for the mounting screws don't line up it appears that this handle is a bit smaller. how do I determine the exact size I will need and then how to I go about exchanging this one I just purchased. Thank Y ... (cont.)

No markings on bracket.

Can the clear plastic drip rails be cut. Our shower door is 27 1/2" wide and 3/8" thick so I think one of yours would work if we could cut it.

Hello: Can you please help me identify these washers which are a part of the shower handle assembly: (1) hard flat transparent washer, 3/4" outer diameter and 1/2" inner diameter (left-most on the photo) (2) also kind of a washer, but conical in shape and its softer, 3/4" outer diameter and 1/2 ... (cont.)

I purchased a home and there is a corner shower in one of the bathrooms. the only identification on it is ANSI Z97.1-1984 NKG. One of the top rollers is broken, and I think it looks like your 10-058 part. My question is, can I replace just the top roller? I don't want to have to drill holes in t ... (cont.)

I have a stall shower with a 24" door that needs a new drip edge. The current drip edge measures just under 23" - shouldn't I be able to find a drip edge that's an exact match for the one I'm replacing? If I use your 10-324, I believe I'll have to cut it down on both ends, and also drill new holes ... (cont.)

i need to replace the shower door rollers, but I couldn't find a similar part, I saw rollers but I'm not sure how to get the wheels off?

Looking for the attached lavatory hardware.

How do you remove a Concealed Latch Knob Assembly?

Need to replace worn out door sweep of my 15 yr old swinging shower door.

Hi - I am going to be installing your 10-324 and my question is... If the sweep gasket material is too "tall" to shut the shower door easily - can it be cut (horizontal cut the width of the shower door) and what's the best rule of thumb for keeping the water IN? Thanks!

Repair it with 3/16 X 5/8 ball bearings and screws and nuts. AMANA TOOL Part # 47718

Hello Can you please help us find a replacement bottom bulb seal for a Neo angle 21 inch shower door. Possible made by American Standard. ( not 100% sure, just google closest to what we could find). Please see attached PDF file for photos and precise measurements. Thank you

What size screw do I need to fasten this shower sweep?