Viewing all customer Discussions for:

Lavatory

Is latch set 10-553 universal in that it will fit most major manufacturers toilet partitions. How is the old latch removed and this one installed?

I am looking at the 10-134. I need top & bottom rollers are they the same? If not could you give me part numbers so I could order them from you. thanks

I am a custodian at an elementry school in Toms River New Jersey and I was wondering if somebody at Swisco would be available to answer some questions for me. The lavatorys at our school are basically falling a part and i would like to have some questions answered about parts that I might be orderi ... (cont.)

Are the stick on finger pulls (10-005) completly clear or are they frosted in the middle and clear around the edges.

What is the thread type and diameter of the thread on the Philips binder head screw? Many thanks. Terry

This handle is made to stick on mirror or glass cabinet doors. For best results, clean the surface well prior to sticking on the handle.

The 10-110 replacement shower door latch does not come with screws. You may be able to reuse the original screws from the latch you are replacing.

These hinges are used on plastic laminate partitions. For replacement purposes, you would install the new hinges into the same spot as the old hinges. Please see the attached drawing. The installation diagram shows how the hinges go together with the door inserts, cam and pintle. The diagram is not ... (cont.)

toilet partition concealed latch doesent lock,how do you take it out and replaced.

Into what other part does the 10-553 fit into to make the "Latch Throw" Does this need another part?

Concealed Latch Set Product Code: 10-553 what thickness can the door be for this to work right?

i am looking for the plastic u channel gasket that goes between my mirrored door and the sliding frame. I have 2 thirty inch wide doors. Thanks, Bob Sampson

What is either the diameter of the threaded studs or of the hole required for them (10-126).

The 10-319 shower door flap is a replacement seal that slips into a preexisting slot.

Hello, Does the 10-126 come with the mounting screws? Your description does not indicate screws are included. Thanks, Gregg

instead of brass finish i need silver finish for the 10-136.

The 10-010 stick-on mirror pull has mirrored surfaces (not clear).

Normally shower door rollers are screwed into top of door with a 8-32 machine screw. Check to see if there is a rivet, if the wheel is riveted on see if you can change out the complete roller housing. As a last resort you can possibly drill out or grind off the rivet. However take care not to dama ... (cont.)

The 10-581 Keeper works with this slide latch and in-swinging doors.

Yes. Installation screws are included in this set.