Viewing all customer Discussions for:

Other

Hi, Im about ready to buy some K&K Casement Window parts, but I cant find one (1) piece. It is the bottom slide that allows the casement to slide from the closed position towards the center of the opening. I tried attaching a photo but couldn't. Thanks Daryl

I am looking for 6 replacement hinges.

Hello, I purchased 'Tandem Roller Assembly' part number 87-205 5/16". Do you know which screws would likely work with this item? Thank you

Looking for the black plastic handle that actuates the lock latch mechanism on the other side of the handle assembly. Good Handle pics show proper length. But after door opened too hard slammed against other half door and broke handle. Bad Door Broken Handle pics (3) show broken handle. I have thr ... (cont.)

I am looking for 2 of each of the following: garden window open/close crank and the locking mechanism. Mine look different than the ones shown on this sight but the works of the mechanisms are the same (perhaps an older model). Your videos on the replacement procedure and troubleshooting when a p ... (cont.)

Hi I'm looking for replacement of #2 rollers

Inside of Case Runner has notation U.S. Pat.R 32.134 Also imprinted with large "31."

I'm looking for a set of window pivots for a 1996 vintage Harvey window . It has the following marking 1640 . Paul c

which one Please help identify this. thank you

Hello, I am trying to replace both window cranks ( left/right ). I cant find the make or model for either and there aren't ny markings on the window either. Any help would be appreciated

Rear drawer glide socket. Mid 1980 Riviera cabinets base cabinet B36PP Sliding drawer glide socket right and left hand? Part number G6020?6 RH. Part number G6020?6 LH. See attached photographs.

Window latch

Please let me know if you have this replacement pivot bar

Here is a picture. If you need anything further please let me know. Thank you,Sue

Need patio door lock replacement. Guardian door.

Do you have one like this?

I am trying to find just the inside handle plate to replace my patio door. It's approx 3 1/4"

I am trying to locate a guide for the locking bar from a simonton casement windows are approximately 18 yrs old.thanks Andy

Need two complete units. Not sure if you have them in beige like the ones I have but I can use white if not.

I have a broken mortise lock on my patio door. I'm not sure of the brand, but the sticker says, AAMA series 870 SGD-R20-96x96. The screw hole spacing is 4 5/8" and the width of the lock is 1/2". Do you have a lock that would fit? Also do you sell replacement screens doors to fit that model patio doo ... (cont.)