Viewing all customer Discussions for:

Other

This flip lock handle broke off and I need a replacement. Product number on the door fframe is 6068. By Anderson Corp.

Hello, I am in need of some weep hole covers. The style/dimensions are the same as your WEEP HOLE COVER, 1" X 3/8" Product Code: 26-417, 'except' mine are 3/4" X 3/8". Do you have the 3/4" version (white).

has 15b stamped on balance i think its off a ply gem window

Window replacement part

My window balances look like the Series 350, cut a customer service rep says it looks like a specialty bottom. it's 7.8" from front to back, as he called it. I need two. 28" long 2730 stamp Can you expedite these?

Latch is 9/16 W x 2-5/8 long, overall length is 3" including spring clip Need (3( RH & (2) LH

Our window cleaner identified a missing weatherstrip on the left side of this window and strongly suggested replacing it to avoid having the glass separate from the frame and to hold weather out. I cannot get a local person to supply the part and install it. Do you have this type of seal? ... (cont.)

Mounting holes are 6 3/4 inches apart. Believe door original to house. House built in 1984.

Please can you help us identify and then potentially distribute to us a set of these coil balances. Do you ship to the UK? Have a good day.

Can I use the 39-031 even though it doesn't have an upward offset or do I have to re-rivet my old link arm to a new operator because it is over 4" and has an upward offset? I also need to replace the casement lock.

Trying to locate this plastic slider for my casement window (IMG1759.jpg). I can't find any name on this window. You previously helped me find operating hardware that I adapted to fit per your video instructions (39-315 and 39-316). I've included a picture of the old operating hardware in case it ... (cont.)

Hi there. I'd like to convert my sliding patio door to a key lock on the handle. Unfortunately, I can't find any info about the brand. Could you advise?

I have 2 single hung milgard vinyl windows that need new completed balancers . They measure 5/8 thick so not sure if that falls into the 1/2 thick product line. One pair is 29 inches ( in picture ) the other pair 26 inches. 29 5 CMC GW 11 and 26 5 CW CMC 11. Need plastic clips on each end , a compl ... (cont.)

GU and a symbol on arm and back.

My window doesn't stand , when I have lift up. It needs parts to hold the spring!

Only thing marked is 20 3 B.S.I OR.

The cast post is broken from the plate.distance between holes is 4 15/16

No markings

Attached are photos of the current broken coil window balances installed. I need help identifying the proper replacement parts. The only identifying marks are "6R" on both sides. The parts inside the window sash are approximately 17/32"- 9/16" deep.

21 4 is stamped on side. It's a Millard window and I need both right and left side for one window