Viewing all customer Discussions for:

Other

Hello - i need to replace three drawer parts: the Kenlin RiteTrak II plastic guide which is oval shaped as well as 3 stopsDo you carry these?ThanksJohn

The part of the hinge that mounts to the face frame broke. You can see from the attached photos that there are cutouts where the hinge mounts to the frame. I have also attached a photo of the actual piece of the hinge that broke. Hoping you can find the actual piece that broke or have the exact hing ... (cont.)

Looks like D53 7427 1085 Same number on both right and left side of window Bottom window glass measures W 28 3/8 X H 21 7/8 Wooden frame About 15 years old

I believe this is a Truth 23 series dyad operator. I am looking for a replacement as it no longer opens and closes. Thank you.

Need rollers for glass sliding door, and replacement procedure. Manufacturer unknown.

Hello we need a replacement for a reflectolite sliding glass door handle.

I need 4 of these for patio doors. A double roller wolf be great. They are on M I brand doors.( Metal Industries.

I need to replace the hardware , or hinges on a right handed swinging. Mirrored closet door. The size of the door is 80 1/2 X 34.

These are pictures from the roller removed from the door. The dimension of the wheel is 1.5 inches The dimensions on the side are 5/8 inch and 1 and 3/8 inch. The dimensions for the outside plate are 1 and 3/8 inch and 2 inches.

please can u let me know if u have the part in the pic

I need to replace the hinge shoe on my Pella casement window and have ordered and received your part number 39-371 with the correct hinge shoe. I wondered if you have any advice / instructions about installing the new shoe in the hinge bracket? The old one had a crack and fell out of the roller sho ... (cont.)

GACO 4070H

Hi, one of the coil balances is broken. The sash weighs about 19 lbs. Could you tell me the right part? Thanks!

Latch for a pella storm door

The crank assembly is by Truth #31850. These are for Crestline Aluminum Clad Wood windows circa 2003. Need 2 each right and left hand units; Coppertone color.

Approximately 7 1/2" top to bottom white frame piece holding part shown in photos. Approximately 4 3/4" center of top screw to center of bottom screw.

1982 patent stamp 4.241,541

The latch on our patio door broke. It mates with a sash control handle with lever stamped pt.1963 2. The attached pictures are of the latch itself.

I think thumb extension should be flat. Picture looks like someone bent it up or out from the door frame. Finish is bronze, maybe brass?

I measured width 11/16" Height 1-1/16" Diameter of rollers 1-1/4" 2 rollers Metal rollers Bracket was held in door frame by the metal tabs. No screws