Viewing all customer Discussions for:

Other

photo of sliding glass door handle attached: distance between centers of the two stainless steel screws is 3 7/8" Not sure who the manufacturer is: one label identifies the sliding door as AFG temp 1027 another label identifies the stationary door as PPG HERCUUTE

This is a corroded part from the bottom hinge of a double pane casement window.

Hello. My wife and I recently bought a home that has casement windows. And there were a handful of these crank handles that are broken. And we need to find the right replacements. We ordered some from you but they were the wrong ones. Not your fault. It was probably our fault. It's really hard to fi ... (cont.)

Do you have a replacement part? Thank ylu

Need window channel balance

Hello,I need a replacement for the above referenced door roller.Thanks,Dana

Could you please identify these part that I will need to have replaced on my wooden casement windows ,then give me an estimate for cost?

Hi, I'm looking for a replacement lock for a ReliaBilt sliding door. Part is labeled as PM52x, as part of installation of a PD3000 handle kit. It's 9 and 3/4" center to center for the mounting holes, 9/16" wide and 1 and 1/16" deep.

We need Truth casement window hardware operators. The Truth descriptions we have are #36-154-1E (R) and 36-152-1E (L). Please let me know which are the SWISCO equivalents, if you have them. Thank you Jim

the rollers are broken on one side of door

I need 4. ty for your help

Looking for replacement window tilt lock.

Looking for replacement sash lifts for Semco double hung window. Both sides of window is needed. There is a part number on the one side "30RB" Photo is of the right side.

This is a latch for an Arcadia screen door circa 1970. Metal tab latch controller snapped off.

By the time I sought help, I had removed the handle. When I purchased the house, the deadbol t was stuck in the locked position with a broken off key stuck in it. Many pieces were rusted or broken, so there was no salvaging the parts. The only identifying marking I can make out is the word FAMA on t ... (cont.)

Hello, Don't know how I did it but I lost track when I was reglazing another window. Can you identify this part in your inventory. It measures 13-3/4" x5/8" The only identifying marks is engraved "press arm to detach (arrow)". in the center. Jay

Older aluminum siding door 48" x 80". Rollers on front and rear

I recently purchased a 1980 condo with sliding windows. Photo 929 shows the broken latch I want to fix. Photo 930 shows another latch that is still good. Please let me know if you have these and the cost. Thank you, Dan

I have older Belknap Industries glass sliding doors with worn out bottom rollers. The doors are series Nordic 9000. Each door has 2 single roller assemblies. The measurements are: roller diameter is 1 1/8", bracket length is 2 3/8", bracket width is 3/4" and the bracket height is 1 1/8". Please advi ... (cont.)

I am looking for one replacement window crank for our casement windows. I believe the color is Stone.