Viewing all customer Discussions for:

Other

Hello Can you help identify the parts that I need this is a setup from one window. About 20 year old replacement windows from a New Jersey company called "window factory"Thanks

This patio door lock is broken and we need a replacment.

It is 1 3/8" x 2"

Hello! I need to identify this sash clip. Can you please assist?

On one side it has a 31 stamped below a 98. On top side it has a 3 which is the length I guess.

To whom it may concern, There are 5 windows that require channel balance replacement. Three window saches measures 32" W X 32" H and weighs 35.5 pounds, the remaining two measures 45" W X 35" H and weights 47.7 pounds. All five windows have the same size channel balance determined by the label on th ... (cont.)

Hi. Trying to replace these. Please help!

Hi, I found NO markings, so can inform you that these are surface-mounted (NOT a corner type). Total length is around 3 5/8-inch. Width is 7/8th inch. Center distance of screw holes is 2 9/16inch. I need a minimum of 20.

Antique window latch front and back

I want to identify the exact type to replace , it says 31C on the old one

Looking for the left and right plastic pieces that support and guide the channel balance at the top of the sash, and that are held by a screw to the window. Channel balance is 1/2" by 1/2" marked 2830. Metric measurements of part are in photos.

can you help me figure out what operator to order as replacement? thanks

Here my pictures and diagrams…. I will also include two photos to see if you think that this will work. The one part is just shy of a quarter inch. The other measurement is just shy of a half inch. Thank you.

I am looking for a replacement for the attached Grant door roller. ¾ wheel, ½ backset, 3/16 thick wheel, 1/8 gap behind wheel, bracket 2¼ wide x appx 3" tall. Thanks, Kirk Harris 304-612-6335

I am a contractor and a sigle elderly woman in her 90s had me come take a look at some double pane windows that were replaced 4 yrs ago and the glazings were incorrect and the glass is on the verge of falling out. The pane and the channel in the aluminum frame are 1" thick. There is a 3/16-1/4 gap ... (cont.)

I have many of these folding closet doors that are missing this particular part.

LH side is totally missing. Afraid to breah the other side removing for photo. Thanks for any help

Hello I am looking for pricing for the following stop. The dimensions are 5/8” x 5/8”. Thank you.

Please help locate the pivot pin. Thank you! The part is from a Simonton window.

Hi, Do you have anything that matches? Thank you