Viewing all customer Discussions for:

Other

need 2 outside key locks.

Hey I have several windows I will need to replace these balances and I was having a hard time finding them on your website. I know they are there I'm just not good with computers Thanks, Lucas

These are off my slider doors . I m looking for new ones . I need 3 set for all my patio doors. The condo people said these were built in the 1965- 1970 . Any help I can give u let me know . They are 2.5 long about 3/4 wide and about 1 inch across .

Looking to replace double latching lockI have a slider that is unmarked and I am looking to replace the double latch lock that broke. I only need the locking mechanism but I have no way of identifying it. Can you please help? Adam

Mechanism is no longer operable. Looking for replacement

Looking for replacement window rollers as shown in picture. Base is 3/4" X 1 1/4". the height to the top of the roller is about 5/8". Do you have a matching replacement. Looking for 4. Thanks

Larson storm door purchased from Lowes 5 plus years ago. Handle hangs down. Door has a top glass that slides down to reveal screen. Looking for replacement for the mortice lock.

The "T" that protrudes out the window broke. What is the part # to replace it?

Tighten the thumbscrew and it keeps the window from opening.

I have Peachtree double-hung windows, cottage type. They are identified as G3692, type AE I need new Spring-balance mechanisms and lower weather strips

Part # 26-4 GK5 CMC 4 27" long

Malta dh 2/78 mfg Balances

there is a tab on the bottom and only a top screw that holds the latch to the door. the two screws that hold the locking part yo the door are 5 in.apart

Need replacement parts pictured. Thank you

Im looking to replace a door handle on my slider.... in door it says AAMA SGD-C20 SGD-C25

I need 6 each of right and left tilt latches.Mark

Pls see attached photo of a part I need for a Simonton Single Hung Window. The clip is retained at the top with the top cap wedged into a clip on the frame. I believe the product code is 19-005. I checked the measurements from your website and they appear to match. However maybe you can cross re ... (cont.)

I can't seem to locate this sash balance. Any ides? Thanks! Stan

Hurd Window made 12/11/01. The window being operated is roughly 21 1/2" x 45 1/2"

We purchased these in 2013. I have close to 300 windows and the locks are breaking. Where can I get new ones. Thank you,