Viewing all customer Discussions for:

Other

All videos I see demo replacing the lower window balance. I understand the actual replacement of shoe & balance is the same, however, I am unclear as to where to locate the shoe and do you add the same amount of tension, etc? Is there anything I need to know that is specific for the rear/upper wind ... (cont.)

I'm wondering what I is comparable to my window sash and lock. I have the Alenco. It's 3 inches long and 1 inch in width? I didn't measure the width between mounting screws but I would say 2 1/2 length between mounting screws. Thanks Daphne

Can't find any markings or numbers. Is this the long or medium slider 38-095 0r 096? I think it is 1 5/8 but I'm not real confident I am measuring the right dimension. I sdon'[t think I have the Roto model but???

hello please see if you have a replacement i am looking for. waiting for your feedback. thank you. ali

Hello, I am having trouble identifying these parts on your site. Please let me know if you can help me.

21 4 AQ Caldwell Stamp Metal part is almost 22 inch long I included a pic with tape measure

Length 2 3/4, screw 2 1/4 apart. Black color. Need 6.

I need help to replace some parts on our Capco windows. It has 2 lifters and one is broke. It's a cable looking design outside and a twisted metal piece inside that goes up and down with the window. That's what I need. I have pictures if that would help.

Hello trying to select a guide for these old windows. I have 10- 13 windows to rebuild. My guess is with the a little modification the guide 18-161 is the one I order.. (my spec see pics) 5/8, 3/8, 1 3/8, 1 3/4. Can you help me verify before I order. I have already failed at ordering and try on a ... (cont.)

Need this Part of the window sashe that fits in the shoe of a balancing system

This is a picture of the door pulls I am trying to purchase. The only part number that I could find is on the back of the medallion. Thanks for taking your time to research this for me.

Need replacement for tilt latch on right side of window

I need

Hi there, Can you advise which Truth model part # I need to order? See attached photos. Thank you! Andy

Replacing some parts on all my windows. Looks like the 19-005 channel balance top is the right one for my channel balances, but none of the top sashes I found looks quite right. Differences are that mine (a) have two screw holes spaced at 1 1/16" and 1 9/16" from top, and (b) do not have top caps - ... (cont.)

I need some Tempco Window Tilt lock replacements as in the photos. They're about 11/16" wide, 2 5/8" long, 7/16" thick/tall and they slide into a rounded slot. Numbers on the part is 8B (right) 9E (left), 75, PAT# 5,139,291

point of clip goes under wood around the glass, there are 6 that hold the frame in place

I need 200ft. of this seal.

The white plastic sleeve has split in half (I glued it together for the photo.) This is the bottom pivot piece for the mirror sliding closet doors. The white bracket is 2" from top to the bottom ring, the spring is 1 1/8" long, the piece with the spring around it is 1 3/4" long and has a 1/4" diamet ... (cont.)

LockSmith re-assy b4 could measure components. Only measure gotten was interior face plates center to center fastener hole of 7.5". Attached photos taken whilst LSmith dis-assy to dislodge door from stuck deadbolt. Your mdl 82-400 info doesn't give a measure for what I got a measure from. Can you ... (cont.)