Viewing all customer Discussions for:

Other

I Have in my cart S380-30 and S380-35 but my plastic piece at bottom of the balance measures 7/8 not one inch and I read some comments that I may need 029 (from Memory) on bottom and you have to make up. Please let me know about this. Also the bottom `Bubble Seal", please see photo, is not exactly l ... (cont.)

Grass made in Austria Part # 1800-63

removed door handle years ago. All inside parts gave out. Looking for a replacement. Screw holes are spaced 4-15/16 apart.

Window ballast Springs are broken as shown in pic 2 and pic 2 I have not seen any numbers or markings on the window It is a single hung Window The lower panel is 17 inches in high (pic 3).

ask abou the patio lock replacement

I have a patio door from LIKIT and is apparently no longer in business. The door is circa 1990. Wheel assemblies are worn to the extent its hard to open and close the door. Upon removal, the axles for the wheels seem be worn. I've added grease, but its still difficult to open and close. I need ... (cont.)

Probably from the 70's. Track is aluminum and close to 3/8 opening for bushing to ride in. The bushing shown must of had a bottom for the 1/4 inch rod or it would float up and down the rod and not stay riding in the track. The rod has a screw you loosen to raise it up and down, which should make it ... (cont.)

10-126, 2 1/2 inch distance between screws.

We have PGT hurricane sliding glass doors. The handles are stripped and need repalacment The inside handle has a slot for door lock. one set is 10' long with screw holes are 3 7/8 apart. other door has handle 8 1/2 in long. Same screw loles and slot for lock

I apologize, first, since I may not use the correct terms/words.I am selling this home, and need to fix window. It is a vinyl, single hung, tilt window. The balance bar there is not covered by a plastic piece, it seems to be held in place by the white clip on the side of the window. I did see 28 ... (cont.)

So this piece is a strip of hard plastic, runs the height of the door and interlocks with another of the same when door is closed. Has a channel for a brush gasket. Door is old, wood, sliding door. Thank you! Jake

Greetings, I am looking to replace a sliding door lock. I order from you guys the lock on the right in the images. The previous lock is in the image on the left. Imperial 7800877 was a sticker on the lock.

Beds replacements

Greetings! 22 year old casement window crank handles, with a 5/16" female hex drive. No names or markings visible on the handle but the window manufacturer was "Insulate", I believe. I need replacements in "white". Thanks for your assistance!

Channel balance top guide Milgard window

The white crank says Ttuth inside. The crank hits my mini blind. I want to replace with a T crank. The bigger T crank i purchased is 3/8" and is too big.

do you have this part?

Need help identifying window balance part # for replacement

I have used parts from a unit from local hardware store.

Truth #05232003 1159