Viewing all customer Discussions for:

Other

I can open the window but it won't close. The crank handle turns but the window doesn't close. The handle appears to unscrew from the unit as opposed to turning the gears to close the window. Can you identify the problem and what parts I might need? Thank you.

Handle is cracked at the base where the pin goes in. Crank works fine. Just looking for new handle. Thanks!

I need to order clips for my screens, also need to have a few windows replaced, so I need to know what kind of windows I have

Looking for replacement for this operator, the best i can gather a discontinued truth operator. will appreciate the help. Also need second one with opposite direction for the other window. Thanks!

Lawson single hung aluminum window Series: SH-7500 Balance Desription 30 inch length 10/16 width Design pressure 63.00 psf positive, 63.00 psf negative

Hi, I'm looking to replace the coil springs in a window. It looks like it matches the s150, but I don't know the balance weight. A stamp on the coil says 840 (see photo if possible). Thanks Bob

Help find wheels that fit this track

Pat number is #:6.264.252 Pat number is #:5.820.170 Handle is 3 - 15/16 hole spacing I do not need the handles just need the brass locking mechanism please

It looks like the 18-064 but it is not 1/8 in from the bottom of the top lip.

I'm looking for replacement tilt window latches. As far as I can tell, the measurements are: 3 1/2" wide, 2" screw holes on center, 1 1/2" length, 1" distance from outside edge to first screw hole. Thanks!

Hi. I am looking to see if you can I'd this pivot shoe. The window manufacturer is Alside from 2004. The shoe is broken and will not engage with the window pivot bar Thank you. Peter

Need replacement tilt wimdow latches per attached photos and dimensions. Original windows are Owens Corning model FDH. On back of latch it shows Pat.#4.901.475. Not finding replacements with the correct dimensions and curved end. Any assistance you can provide will be greatly appreciated! ... (cont.)

Spring does not allow the upper clamp to rotate/spring into position. Not sure if I properly collected all hardware, so I may want to also know which new handle set to match with. I included the serial number on the door itself in case that makes a difference.Kindly advise.John

Pella double hung window. Pivot bar broke.

Please advise on the part that I should order from Swisco.

I am searching for replacement window balancers. I am having a hard time determining the correct ends. The metal is 31" long x 1/2" . Stamped on it 30 3 D H. The wings measure 15/16 apart 1"deep. Any help would be greatly appreciated. Thank you

Hi, my neighbor asked me if I could help find the part that helps his hinge basement window stay locked, but I can't seem to find the part.

Trying to fix up my storm door. I need this snap in bead. Preferably grey or black.

Looking for these parts. Part numbers listed are from Windsor web page. Crank handle & cover RH 552112 qty. 2 Crank handle & cover LH 552012 qty. 2 Lock handle & Escutcheon 553112 qty 6 Contour cover 558223 qty. 2 Contour crank 558218 qty. 2 If you sell these could I get prices please. Thank you ... (cont.)

Balance is needed for this window. That picture is of good side. Its the other side of the window that is broken.