Viewing all customer Discussions for:

Other

I have a 4ft x 8ft sliding door made by TM WINDOWS MODEL 390 THIS IS A HEAVY HIGH IMPACT DOOR I NEED THE CORRECT ROLLERS BECAUSE THE DOORS ARE SO HEAVY I DON'T WANT TO REMOVE THEM UNTIL I HAVE THE ROLLERS. I WOULD APPRECIATE ANY HELP YOU CAN GIVE ME. PETE

Hello: I need a window crank, as shown in the pictures I submitted. I purchased from you (and it works and I will keep it) part 39-205. However, it does not fit perfectly as the original crank was slightly curved or bent and the 39-205 is not centered perfectly over the crank mechanism. Do you fo ... (cont.)

The vinyl strip on the window glass in which the keeper part of the lock is attached has broken off. The windows close, but do not lock. I am looking to buy parts so that my handyman can install.

Hello,I have attached three (3) photos showing the types of replacement parts I need for a number of my home windows. The windows are 20 years old, and I believe they were made by Simonton.I would like to purchase a number of the plastic covers/holders for the balance springs, and also the correct ... (cont.)

Bought a house shell that has been standing for 11 years. Four wooden sliding doors had been installed with the internal hardware already installed as well. The doors where made either by MW or Ply-Gem. I have the hardware (photo uploaded) for two of the four doors. This hardware was made by HS+ ... (cont.)

need to replace rope and tilt window latch

Looking to order S795 balances with the 15-198 top clip and the 1 ¼" t-lock balance shoe 8 x 27B 2 x 27A 2 x 27C

86 26-5 CB5 CMC 1 I just need help with ordering the right sizes as my window balances seem to not quite match what you have in stock. Any help is appreciated. Thanks

HelloWe need the wall plate that matches the door handle, do you by any chance know what this may be, do I need to take any measurements.If we cannot find a math do I need to buy a new handle and matching plate?Thank you! Alison

Need to find a replacement for this lock. It is 2 1/4' hole to hole and 1 1/4 front to back. The latch does not extend past the casing so it needs the right keeper as well.

Channel measures 28" (metal only) Stamp - 27 3 GX CMC 11

I need to find a keeper that fits inside the channel and will work with part 82-005 surface mount door handle assembly. Do you have suggestions?

I ordered #70-219 they are to short These screen are off of MArvin Windows Can you figure out the correct part number? thanks Mike

Window approximately 64 long 29 wide Slide window a (Cardinal )

These are used on each side of our metal crank out awning style windows. 6 windows. 2 support arms per window. Most of the plastic/nylon guides are cracked or portions missing. The plastic guides are fabricated to be part of the bracket and not designed to be removable.

Hello My door bracket broken,I find you have,I am not sure it match my old one?

Hi here is a picture of a piece for my bathroom drawer and my sons kitchen drawer. I have no idea the name or part number

My 1988 merilat drawer broke Do your parts match the pictures??? Thank you

I need a tilt latch for a Showcase window originally installed in 2003. I have attached pictures of the window attached. Please help me find the part I need to order. Thank you for any assistance you can provide. Let me know if you need any more information. Ron

I am looking for roller assembly for 22 year old Masterview windows. Single 1/2 roller, plastic housing. 1" long X 7/8 tall X 1/4 wide. Can you help? Tabs are broken off the top of the assembly on the roller in the pic