Viewing all customer Discussions for:

Other

10 LB SERIES 140 QUICK-TILT, SINGLE Product Code: S140-10 Is this the correct replacement part for the attached photo?

Reg# 35013032. 112040712 Door henge riveted on one side of door trim and screwed to the door by 2 Phillips head screws. Need 4 henge

Hello, In reviewing your 3/8 balances for non-tilt windows I do not see one that looks like this. Can you review and let me know if you have something that would work? Thanks, Jay

Good afternoon, my name is Patricia and my kitchen cabinet drawer door is broken. The clip inside of this bracket ( I'm don't know the name) broke. Do you have this part? If yes let me know how I can buy one. If not do you have any idea from where I can find it. Thank you so much!Please contact me a ... (cont.)

The metal with out the plastic is 21 . i believe the part is called a Channel balance. Window does not tilt

Do you carry a replacement for the Hurd casement window hinge? On the arm there are two stampings - 9693P and A93L

Hi, I've been told my windows are from Gapco and it appears you are their parts people. Help please. Several of the window tilt latches have deteriorated over time. A few pic's are included. It appears I need the 26-393 but request your advice. Thank you! Steve B

Also need help identifying this part. It's 2 5/8 long 11/16 wide rounded back

The dimension between the screws is 3-7/8"

Looking for this part,

I would like to purchase (4) of the part shown above Thank you,Joann

Please help, if you can. I'm looking for one replacement Thomasville dresser pull. This dresser was purchased approximately 25 years ago. Thank you!

Andersen single hung Winddows do not stay, The diamater is 3/8 29 Lenth for four windows needs 8 spiral balance, and a window 3/8 diameter 13 Lenth I need 2 spiral baalance, as you can see and the picturo green color , not sure which serial number to order, please help me out.

Good Evening, A couple of my double-hung window panes fall down when unlocked (top pane) or don't stay up/open (bottom pane) and it appears that the pivot lock shoe is missing on some and damaged on others. Attached is one of the window's label as well as the part needed. Your assistance in identif ... (cont.)

I am looking for replacement part for drawer slider T31 220M400 bracket . Thanks Paul C.

I'm looking to replace these window cranks for some steel casement windows.

Hello, I am looking for assistance to identify the correct window balance replacement. My current window balance is 24"x 1/2". The stamp on the side is 23-4. Thank you for your assistance - Pat

Hello, Both of these wheels sit in the plastic fittings shown here and that sits in a receiving channel below. there doesn't appear to be any method of adjustment other than adding a plastic shim where the plastic fitting hits. The main issue appears to be that both these bearings are busted. May ... (cont.)

This is a window crank for an awning opener. It was installed in our cabin decades ago after having been salvaged from a still older structure. There are no manufacturer's marks on it. The holes along the long axis are separated vertically by 4 1/2" The lower holds are separated horizontally by 1 ... (cont.)

The coil balances are sprung