Viewing all customer Discussions for:

Other

I am looking for a Wright Fairmont Storm Door Mortise Handle and Lock. It seems to be discontinued in a lot of places.

I have Alcoa windows. House was built in 1995. I need a lower half of a window that can tilt out. The glass panes have moisture in them.

My Mastic windows were installed in 2001. Most are in really good shape except for the tilt latches have snapped off in a few. Do you have parts to replace them? It looks as though they just snap in -- no screws.

I have a EMCO white 36X80 storm door full front with summer screen replacement. The bottom two hinge pins have broken (there are four onn the door)can you supply replacement parts. What is involved in the installation?

3 1/2 by 3/4

Hello, I'm looking for the replacement for the window clip that holds the window into its casing. Thank you Diane

Locking mechanism is missing located next to handle.

Any ideas which part would be compatible with this? It's from an Eichler home - I believe it's an Arcadia sliding door from the early 1960's.

"8" stamped on coil - picture 2. bathroom window (smaller) so only 1 coil per side "E" stamped on plastic part

Can you please help me identify this vinyl snap in glazing? I previously purchased one that was 9/32 in. x 1/2 in. (see the picture) but it was too big to fit into the opening and did not have the small grove along the edge. I don't know if the small grove matters as long as it will hold the glass i ... (cont.)

this window is missing the right and left handed latches that hold the window in place and also allow you to change the window position in the door. I've spent a lot of time on google today and I've found such latches for sale but I can't find them now. One site showed a narrow spring I think goes b ... (cont.)

This roller is from a Patio Door installed in Florida (Tampa Area). There are no identifiers on the Roller, nor on the Door. Need to purchase rollers for all three patio doors. Any help would be greatly appreciated. Thanks in advance

I have a project with some missing vent latches. I was hoping you could help identify the part number if you carry it. Thanks

I have photo of parts on my email I tried to forward photo email to www.swisco.com from my yahoo email. Yahoo said check the email address

Screw holes are 3 and 1/2 oc. Everything I can find has a different alignment.

American integrity casement window. Need handle and crank

Hello, I am looking to replace the locking mechanisms and hardware on my early 60's sliders. Any help would be greatly appreciated, Jeremy

We were in the process of getting this window cleaned and the track seems to be broken. I will need to replace it ASAP.

These are the pivots on the bottom of the casement window. Both are broken. Can you identify them and do you have them available?

can you match this hardware? THANKS