Viewing all customer Discussions for:

Other

I will need two of these I cannot identify the brand or the part number thank you

need replacement vinyl window tilt locks with or without screws measuring 2 1/4" long by 5/8"

Need new latch

I would like to replace with new ones. See attached pictures. The house was built in 1990 so I assume the original parts are from around that time. Also I would like to replace the cover and crank handle with new white ones. Which parts do I need to buy? Can you send me the parts list for the full s ... (cont.)

Looking for 4 clips to attach screen to jalousie front entry door

Hopefully, you can help me. Here's the specs: Milgard Trinsic, 2630 SD2, 1" setback, Ext White/Int White U-Factor: 28, SHGC: .22, VT: .52 1/8" SunCoatMAX (Low-E) Tempered over 1/8" Clear Tempered Argon Gas Filled Tariff Size: RO 50"x80" Net Frame 59 1/2" x 79 1/2" Model: Sliding Door Two Pan ... (cont.)

Hello, I'd like to order a replacement window balance "Photos attached" What is the correct part # Thank you Gary

Push style paths with about a 1/4" inside square rod

These are small springy "u-shape" light metal (aluminum?) clips that hold our windows in place. When I search "jalousie window clips", I don't see these, I see something else that would not work in our windows.

The alum housing for the roller is 2" in length (see pic 2). It looks like it may be "Barton Kramer" but I could not find an exact match on their website. I need one roller for sure but preferably two. Or any replacements that would fit in the pictured door frame. The adjustment hole is 3/4" from bo ... (cont.)

I am looking to replace this 15" long balance as the string broke.

Looking for replacement spiral counter balances. The vertical spiral is a 3/8th and 27 inches long. The bottom carriages are in bad shape as shown and the rods from the window have corroded and broken off. Need help to identify new spiral counter balance and and how to replace corroded bottom rods. ... (cont.)

Do you have this part?

It says it's made in W Germany. The bottom piece that contacts to the cabinet door is 3cm

Do you have this part to replace the broken one rather then whole new rails

I need to replace these shoes. I need 8. Thanks

I'm looking for the relacement roller for 1987 roller. The pic shows old beside a new but incorrect roller.

from a dresser set purchased from Bob's Discount furniture approximately 25 years ago. Marking looks like P-1593. (4 1/2 inch center to center mounting holes) Or do you have something similar?

I recently purchased a cabin. It was built around 1935. Some of the window cranks need to be replaced. None of the windows have any markings on the to identify who the manufacturer is. It appears that a couple of the cranks have been replaced, The manufacture of the replacement one has this marking ... (cont.)

fits in hole 7/16" x 1 5/16 for vinyl slider