Viewing all customer Discussions for:

Other

I purchased 32-119 and had to trim the length and juggle with exact placement/alignment on the cabinet back panel's bracket rail. The bracket rail was used to keep the original L-bracket seated and aligned up+down. The flat back 32-119 spins in place since only one screw can be used to secure it t ... (cont.)

Need 6 closet door guide like the pictures

Hello, it looks like you don't carry this top guide anymore so please let me know if there is a replacement part. I read perhaps 23-044 might work but not sure as from the pic on your site it is not clear how the slider stays in place against the top rail. Any guidance would be appreciated. Sincer ... (cont.)

Do U have rollers like this in the picture?

The name Allen Stevens Corp Woodside NY A number in a circle is 6049 is on one side of the part.

Older model sliding patio door. Latch evidently worn out and will not operate as usual. There are no names evident, but there is a symbol that looks like an abstract Sc on the side of the lock mechanism. (See picture). I tried to use a ruler for help in your identification.

The part needed is attached to all edges of the sash ( not frame)

this handle will open the window but when i try to close it the handle unscrews from its base, do you have a replacement ?

A sliding bolt from the inside of my shed door - securing the door to the shed floor in order to "lock" the door in place.

I am servicing a few dozen PVC single hung. Some of them are without the block and tackle balances, which I have identified are similar to your S770 series. I do have the sash overall height and the weight. If the sash height is 34 inches, what would be the balance length?

Hello,I looking for a replacement window sash holder. These parts are 5/8 wide thanksDave

I need a replacement for this parts do you have it ?

i need to replace the entire part pictured (metal, plastic, everything inside, the whole shebang). Number on part is 2730. Can you help? Thanks! Measurements are within pics, long metal piece is 28" long, other stuff as pictured.

Hello I need to locate these rollers for a vinyl window, size is 2 5/8 long, 5/8 wide and 7/8 tall with single roller. I do not know the original manufacturer of the window. please let me know if you can help.

I need these for windows that open with arm cranking out they hold arm up in place shipping to pa do you have these to sell ??

This part lifts the locking slide mechanism.

My lock broke. Can you help me get the right part please.

I have multiple windows that will need cranks but I want to start with just this one. My contractor ask for this one a hinge and a crank but the other windows just seem to have crank problems. Love your help on this. These are Crestview windows [came highly recommended???] purchased in 2003. ... (cont.)

This corner connector is 5/8" x 1/4. The 2 corner legs are 1/4"x1/4x5/8".

I need to replace several non-tilt window channel balances from 20-year-old, single-hung Alenco windows. The length is 28", width 1/2". The imprint is 2730. Please let me know if you sell something compatible. Thank you.