Viewing all customer Discussions for:

Other

I have an old kitchen solid wood cabinets. Seeking six 1970 hard plastic kitchen drawer slides to balance the drawers.

Hi, I'm trying to find the part that matches my existing top sash stops. I have added the measurements to one of the photos based off of what you guys show on your new parts. It was a little overwhelming trying to match mine so I thought i would reach out! Thanks! Kevin

Marked "26 3 caldwell", approx 27" long Which model do I order?

We are needing to replace the hinge operator and crank for the window in the photo. The actual window is the exact same window and operator but the crank is on the left side. We can't open the window since it is broken, so I sent a photo of the identical window with a right side crank. I've looke ... (cont.)

I am in Prescott, Az as well and have this latch that has broken. I would.like to replace it with whatever latch you have that will fit the window. I would also like to get in the brown color if possible

Looking for a replacement part for my kitchen drawer sliding bracket.

Patio key door lock inser

this is a bracket that holds the lock bar in place on the right inside of the window fram

Hello.I'm looking to replace the sliding door handle/lock. I'm unsure about which part number. The only part/model number I can find is a sticker on the sliding door (not sure if that helps).Thank you for your assistance.

I need an inside handle for this sliding glass door latch, don't know what it looked like

I need window balancers for two windows. They seemed to be the same windows. One window sash weighed 19.4 lbs approximately and the other was 20.4 lbs approximately. The window sash on both was approximately 34" wide and 29-1/4" tall. I didn't find anything on the actual window or parts to identify ... (cont.)

Need to order 3 handles for my cgi patio door sliders for series 4130 . These are the outside one without the lock as pictured. Got quoted 62.00 each which seemed a lot. Is there an equivalent?

These are non-tilt windows, single slide. The part says 14 in. on it even though it measures 16 in.

Greetings, I've watched the videos and just want to verify the parts numbers prior to placing an order. I've attached 3 photos, including one of the Simonton label from the window. The spring is stamped 10J. Can you provide the correct part numbers? Also, from watching the videos, it appears I nee ... (cont.)

Can you help me find a compatible keyed handle for my sliding glass door? I took lots of pictures including a tape measure for the holes. Also, I found an installation warranty sticker, but I don't know if it will help. (MI Windows & Doors 26772002.1 1610) Thank you

Handles are 10inches, with mounting screws on 3 15/16 inches. Duel latches. Need about six sets to replace broken ones

25.5" length, metal frame only. About 9/16" wide

Need to get 2 of these balances. If there is a comparable one that doesn't have the clip style, if not no worries

I would like to buy balances for my Loewen single-hung tilt windows.I think I need to special order because they are nearly thesame as the S751-37 (36TG), but mine have smooth (non-ribbed) channels.Here are the details:Type: Loewen single-hung tilt windowOverall window: 39"w x 67"hSash: 39"w x 40"hS ... (cont.)

I'm replacing old pocket doors in my house. House was built in the '70's, so all the hardware is dated. It took me quite a bit of elbow grease to get them unhooked but I did it. I noticed you have what looks like an almost identical roller system. Do you think your replacement will work for me? (Pro ... (cont.)