Viewing all customer Discussions for:

Other

Thank you for your help.

I bought this one from you but I don't know how to put it

Hi, I'm pretty sure I need two 2820 /S390-29 channel balances. It's a standard 29".This old NUPRIME window is also missing a lock. Is that something you can provide? I included a photo of what remains of that. I see a NUPRIME window sweep lock (90-042) on your site. The screws on my old lock are 1-1 ... (cont.)

I have no idea what this is even called. But its missing on one drawer. Can I order just that or a whole assembly?

I need to replace 2 handles on a New Standards The Steve Tyrell Collection chest. I would greatly appreciate your help.

Just need rollers for an 8 ft slider

Hi, can anyone tell me if i can get a 81-256 with 1.5 inch wheels?

I'm missing one of the front door guides and one of the black skinny pieces that looks like a piston. I've pointed to both on the photos. These are for a bathroom vanity drawer. I cannot find any manufacturer markings on the parts. Thank you!Anne

These are four pictures . Two pictures are the broken parts , one is the area where the hinge goes, and the way it should fit.

I am searching for a replacement for these. I need two sets of any latch that might work. I have been searching for a while now and have not been able to find a replacement. any help or recommendation would be very much appreciated. Thank you for your time, John Wilson

My windows Coil Balance is broken. It has two coils, one of them is broken. It look like part "Series 160 Balance" but I am not sure. Please let me know which part I should order. Thanks.

I am searching for replacement weatherstripping for my Wenco windows installed in 1998. Kind regards, Melissa

We can not identify the brand of window we have so am hoping you can identify this

1/2 wide channel by 23" long. Springs for D-30 are 10" long. Springs for D-40 are 11" long end to end. The 30 has 14-03-97. The 40 has 12-05-96 printed on it.

Inside handle...1060-1943 Outside handle...1963.

no markings on the crank. Built in 1985. It does operate, but the stem seams to be stripped. it's about 3 7/8 from hole to hole. Any advise is greatly appreciated. Thanks Dan

The far left arm is about 3" and the arm connected to the main crank is about 5" When it opens the 3"arm actualy pushes out the sash....can you help? Thank you

Hi. The window balances that I am needing to replace are 24 inches long and 1/2 inch in width. They have 23 C written on the side in one direction and then what looks like an incomplete 3 and .S.I. written in another direction. Thank you for any help!

Truth 7 34 LH

It's similar to your 23-064 but not same dimensions