Viewing all customer Discussions for:

Other

Go310927819-NFRC PellaTstar Dec 29 2004

Hello, I am looking to replace the operator in the attached photos. I can't seem to find the exact measurements. Is there a replacement for this?

Main body: 3 1/8" long Width: 11/16" Height: 1" PLUS a "tab" of 1/8" on top (opposite the wheels) Wheels: 1 1/4" I suspect this is a "Milgard" door, but there are no identifying marks or labels. I have attached many photos for your reference. What part do I need from you? Thank You!!!! ... (cont.)

Good morning,,, hoping you can identify the window locks in the photos as well as the corner piece for the screen. Need 4 locks (2 right and 2 left) if that matters and 16 screen frame corners thank you

Looking to replace door track 48" and rollers

Hello, I need to order new block and tackle slides for my windows. The photos show the two sizes I need. I need to order 2 of the top part (longer) which has "33 4 EX CMC 4" written on it. I also need to order 6 of the bottom part with "27 3 EX CMC 4" written on it. The second image shows the top ... (cont.)

Roto engraved on bottom, installed in 1998.

Hi can you please help me find a handle set with the key component so that I can open the door from outside? The sliding door was made by JV. The two screws are 4 inches apart.Thank you in advance for your help!

I need this part what is it called where can I get one

This is a single arm window crank. Arm length from the bend is 8 1/2". Crank mounting holes spacing to the mounting plate is 3 1/8". There are 4 Mounting plate holes to the window frame. Outer holes spacing is 4 1/4". Inner holes spacing is 2". I think it is Silverline window and the crank has a sta ... (cont.)

I need to replace a few of the weather seals on the bottom of the windows Do you still have these and if not would the kerf weather seal your part number 58-200 work even though it's a sweep for doors I thinkThank youTom

This part came with a Simonton replacement window I need another 24' of it 4' length will do thanks Jim

I need bottom seals of the windows for Harvey windows and those little seals that have the fluffy strip where both panes meet ,on the double hung

Need to replace two operator units.

The numbers are two pairs of numbers on my balance and they are: 11600-17 19 5123 T 8 I want sure I get the correct replacements and have attached phots. Your assistance will be greatly appreciated. Thank you. Tom

3375 Stamped on Steel channel. Looks like a 385 or 395 Balancer. Thanks,John

27x42 3/4 glass frame.

This looks to be a GU manufactured window, There aren't any part numbers listed on the crank.

I'm looking for the lower rollers for a Andersen Silverline sliding glass door 5800 series it's a vinyl

Hello, I am looking to replace the window operators seen in these two photos. Window one seems to have the number 6077. Window 2 has the number 3095. Please let me know if you need any additional information to help me purchase replacements.