Viewing all customer Discussions for:

Other

I need four of these top guides. Since they are plastic, I could cut them down or re-drill the mounting hole if necessary.Albert

I need replacement drawer bearings or slides. They are approximately 3/4 be 1/2 inches by about 1/8 or 3/16 of an inch thick

The label on the window says mastic windows 2222/2230/2232 hung pl# 466-003. It seems that the top part of the lower pane is disconnected from the window sill and that pane keeps falling over, and it seems to be because of broken tilt latches.

The mechanism is not working properly, I can open the window, but when closing, it gets blocked.I hope you can help me, it looks I need a new mechanism. Thanks, Constantin

Can you help me identify this part?

I am not sure what the numbers on the spring mean? I need to buy a few of those springs for my window repair. Just like to be sure. Can you please let me know? Thanks Jack

Window

I purchased your parts #26-243 and 26-244 but they are slightly too large. Do you have anything else that might work? These are 20 year old windows, builder grade. I have no idea who made them. Thank you for any help

I recently purchased a home with KK windows, but for some reason they do not havve screens on them. It appears that the window is set up to receive manufactured screen but these windows do not have any. Is there a place in the USA that I can buy these screens?

I have a Silverline sliding patio door. Does the 82-086 fit this door?

THE BRASS ON THE OLD HANDLE LOOKED SO BAD, I TRIED TO SPRAY PAINT IT. NOW, IT'S EVEN WORSE. HEH, HEH. REPLACEMENT NEEDED. I BELIEVE THAT IT IS A MW SLIDING DOOR, ALTHOUGH I FIND NO ID ON THE DOOR ITSELF. IT WAS INSTALLED IN 1997, WHEN THE HOUSE WAS BUILT. ALL OF THE WINDOWS IN THE HOUSE ARE M ... (cont.)

Hello Swisco! I need a 32" replacement channel balance (set) but I'm not sure which one to buy. The markings on my failed one are: 31 5 EV CMC 2. I have attached photos. Can you offer guidance for purchase? Thank you! Phil

pat no d-198202

part#49-191s

Pacesetter storm window Fastrak II Finger Latch right and left sides

I need 2 Balances. 1/2" wide. The metal channel length is 27 15/16"'s. The window weight is about 19.8 pounds. The window balances that were installed, are probably to heavy - strong for the weight of this window. The is a part number on one of the attached photos. Thank you.

I need to the black corner part that fastens to the corner of the window frame that hold top plastic part of the Balance.

Need a part number for this item. It works, but not well enough to keep. Need all parts that are needed for this to work and be stored.

The Pella windows are about 15 years old. Screens are fine it's the latches that's are missing from some of the windows. I measured it and it looks to be 1inch. Any luck with helping me?

Looking to replace this lock from a forever view door # L314234