Viewing all customer Discussions for:

Other

I need 4 of these. Metal channel is 1/2 wide and 33 inches long. Plastic ear broken off one end.

Looking to replace side pins for full screen

I measured 23 in length and 5/8 width This picture is from top to bottom of same balancer. This window has 4 balancers on it. It is the top window part that makes it fall down when unlocked.I have two windows that do that. Thanks Randy

Hello,I am looking to replace several spring balances out of my windows at home.Windows are: Yale Ogron - Series 1700The balance that I need is labeled as: 31-69 LBS Ultra-Lift 5 GBCould you please provide me with a price for these and/or an equivalent upgrade and lead time.Thank you,Mark ... (cont.)

I need this replaced . Is this considered universal ? Sincerely Vicki

I am inquiring to see about re-ordering 3 of the following, NAME: 26-5 Series 755 Type 16 Channel Balance, Non-Refundable CODE: S755-26-Q0352. Thank you!

I've had this screen in my shop for too long. Any help you can offer will be greatly appreciated. Thanks Mike

2430 BSI is stamped on the long part. The cable broke when I was closing the window. The long metal part is 25 inches. I have photos showing its mate in the window and the stamped number.

Hello Swisco Expert! I need to replace a sash window coil balances pair. Please see attached photos, which include measurements. Additional info: - The shoe is stamped 550 Pat.#5,704,165 - Coil springs are 1/2" wide. The coil closer to the shoe is stamped with the number 8. The coil further away f ... (cont.)

Broken hinge for crawlspace door. Says blum on the round part. Cant find one on the site that matches the wall mounted side. Included pictures of an intact and installed one, as well as the broken pieces installed and removed.

I believe I have a 12 year old Harvey slider which of your products match? Thanks

As far as I can tell with my window cleaning guy here, we need 6 Inner 34 inch and 6 Outer 40 1/2 inch window spring balance complete replacement. Windows are maybe 20 pounds each pane? Please help me get the right parts here so I can enjoy working windows! Thank you.

Need to identify door/ locking mechanism for sliding glass door

Good Afternoon, Could you please help identify which is the correct channel balance to purchase to replace the following item. 21 inch Channel Balance Stamped: 20 4 BN Caldwell Based on the measurements and photos, it looks like the 380 or 385 should work. I am unsure about how to measure the t ... (cont.)

Do you have the trim or do you know someone that mite?

The extender has the k look otters G-U on it. The windows are about 6' tall so there's a lot of pressure on this part when cranking it open. Because the base is broken the handle just spins with no effect on the window. What part do I need?

I'm looking for a replacement roller shuttle and end cap for an old Grass Dymatic left-side cabinet drawer glide for a bathroom vanity cabinet (probably manufactured around 1980). I've attached a number of photos of the left slide and of the right side slide for reference- both installed and remove ... (cont.)

I believe these are from an Atmos window. overall length is 2.25", lower width is .625, upper width is 13/32 and depth is.50 and flush on the outside all the way up. The only marking is the number 6 below the top hole.

3230 channel balance, measures 33" with out plastic ends can't tell correct ends 1/2" width

The only marking I can see is Win-Dor underneath the track. They don't have cranks. I would like to get cranks for them if possible or replace the entire mechanism if I have to. Thanks!