Viewing all customer Discussions for:

Other

I want to replace this part so I can open this window.

Looking for new operator

Hi! Looking fora replacement screen corner for this screen.

I am pretty sure my sash is S390-28 (2730). I measured the current top sash cams but clearly they are broken so I am not sure which I need.

Patent 6679000 and 4610108. Top of piece is broken hence replacement need

This is a wood sliding door. About 68" wide. Looking for a new bottom track. Can't find the manufacturer. Should be from 1991 or so.

1/2 x 5/8 x 24" channel 1 1/8" bottom plastic end depth, 13/16 top & bottom width 23 lb. 27 1/2"x 45 3/8" sash stamped 2390 BSI AM 26 i came up with a part # S385-24 option 2350

Hi, I am trying to replace a broken patio door handle, almond color. I guess I would have to replace both sides so they match. I don't know the manufacturer. The space between the screw mounts that go through the door is 4" 15/16 on center. It was made in New Zealand, it has a key and latches on bot ... (cont.)

Please help with the channel balance selection.Thank you,Louie

Hi, house was built in 2000. Looking to replace the broken ones and have some spares. Licensed contractor in MD, this is for my personal home. Any help would greatly be appreciated. Thank you.

Please see photos attached and the coil spring broke and need the whole part replaced. It says 10 L on the part. Thank you

I am looking for the pegged part that fits into the back of the cabinet. It hold the drawer slide.

Snap in kind. 1 1/2 inch wide The little projection that snaps down into the track is about 1/4" (seems just slightly over that but close). I had thought these windows were Pella as some in our home were marked Pella and some were not. I thought the design and serial codes were similar to the ones ... (cont.)

Need interior handl replacement or full handle set.

Only markings found were the numbers 3220 cc B.S.I. they are 33inches long, 1/2" wide, and almost 5/8 deep

I have 3 windows (assuming I should replace the. Balances in pairs, so I would have a total of 6 balance assemblies) that I need to order the dash balance parts. If it comes preloaded in a kit with all of the springs attached, thus allowing me to just pop it into the window when replacing the old ... (cont.)

It holds the window in and pivots it

Part 36-048 but in left ? lol can't seem to find it on this one says right hand shown

Please let me know what parts do we need to fixed this ?

I have ABC manufactured non-tilt windows and I need replacement balancers for "26 3 FW CMC 10". Does this type of window require window balancers that have winged guides? Or can I use non-winged guides?