Viewing all customer Discussions for:

Other

I am looking to replace hardware on my windows. On the inside of the glass, there is a stamped number that reads INE-89. They are tilt-in windows made of vinyl. Any help would be appreciated. Don

I have cabinet shelving and the plastic clips that hold the shelf are broke.

NEED REPLACEMENT REG NO 03279794876 29

Hello, I need two replacement sash balances, stamped on existing parts: 11600A 17 927 Which part number can I use for replacements?

Do you carry the insert in the 40-150 for the square spindle 4-1/4

Crank replacement

Dresser Handle, 5 1/4 inch total width, 2 1/2 high, screw holes center to center 3 inch. Marking: BPC3234

Hi there, Our patio door's mortise lock is still in place but the handle are broken and gone. I measured the mounting screw holes are 5-1/2 inches apart. Any suggestions or products available? Thank you. Edwin

Sir, These strips fit in a vertical groove across the lower section of the upper half of the window. To install , the widest part of the strip's thin edge is pressed straight down into the receiving groove, approximately 1/4". When in-place , the small section's narrow edge rests snug against the wi ... (cont.)

I went to home depot and was advised to screw the drawer stop in like the picture on the left but your horrible diagram looks like u should screw it in like the right drawer stop( pics I have attached). I really need help to me a person who doesn't fix things your diagram is horrible. I understand y ... (cont.)

Do you have a weather strip to fit Ador Hi Lite windows

All of yours have two wheels

keyed door hande

side tilt latches

window latch for a wood type window 2 5/8x3 inches no.'s on the inside 40226

I need assistance locating replacement window balances for my MW non tilt double hung windows. The home was built in 1987. Please advise whether you carry the requested part and, if not, who might carry it. MW windows was purchased by PlyGem in 2004 and does not provide replacement parts for the ol ... (cont.)

Looking for the piece in the bottom of the window that attaches to the balancer. Image 172 is what I need. Image 169 is what it fits into.

I need a few of these parts for a window that I

We are looking for the white plastic sleeve that the drawer arm fits in and it slides on to the back bracket. It is for a drawer at our church that has been broken for over a year and have not found the parts.

I have an aluminum door opening 3070 x 1 3/4" with the following markings on the plate centered beneath the full lite of the Dark bronze finish door: "ANACONDA" "AMARLITE" The alum door is CENTER hung in an extruded aluminum frame. What I need is the mortised weather-strip x 7'0 length for the ... (cont.)