Viewing all customer Discussions for:

Other

Need 2 window channel balance as pictured. 29 inch, not adding on plastic ends. I've looked for numbers on these. None to be found.no brand name either. Hope you can help me out.

Looking for replacements wheels S&S RB-25 (also has a 2 on it as well)

I need this replaced and would possibly want the whole system

Hi Team, I am actually looking for the rollers to my stegbar sliding door. Dont know if this constitues of a Stegbar ID, but i have it as #62680011, Tempered. Hpe to hear from you soonest. Thanks, Chloe

Do you know what your comparable part number is to replace the above? From your website it appears to be 81005 but don?t know for sure. Thanks

Hello... I just bought the house and there is a patio door with sliding doors but the handle does not have a lock from Inside. Can I buy the whole handle with the lock set? And what type of information I need to buy the correct one. The information on the patio door is SERIES 8670 AAMA / ... (cont.)

I need a replacement operator for a milgard 3510 casement. What part should I be looking at from you

Looking for Pella Screen Door Strike(Tan) - Pella part number #0CZXB000 Similar to part 85-020A that you sell but the one I seek is plastic and tan, not steel. Thanks!

The numbers on the handle is : Ideal Dx-1 D-42.320 When we came home and grabbed the handle it fell off. Do you have a replacement and could you tell us where we can buy one. Thank you Eleanor

Markings on the balance 27 9 BW CMC 4 The window would not stay up and appears one of the balances is not going to work. Mfg of window shows to be 'BFS' How can I order

I am looking for the guides that are located on the front inner stiles for merrilate cabinets installed in the 70's. they are a small plastic guide that look like the brackets that support the shelves on the inside of the cabinet. Thanks, Steve engelhardt, Havre, Montana

I know its a s170 but not sure which one

Please identify (with part number) the correct mounting screws for the 3" Pivot Bar part 26-378. I am prepared to purchase a small supply of pivot bars but I also may need some screws. Pictured is attached. Thank you!

turbo II window balances

Looking for 2 3" radius black plastic screen corners. Biggest I have found is 2 1/2". Thanks

Looking to replace a "DTC 2c6" hinge. It is for a corner cabinet and the degree of opening is greater than 110 degrees (maybe close to 270?) Thank you for any help you can provide, been looking for over 6 months.

Is your balance, part number 26 6 AX CMC 1, available? Thanks, Larry

spring does not hold window up in open position

we need a key lock of siding door the inside of outside handle ... PT1963

Window balance part number 34D26 B.S.I 35" long, 5/8" deep, 9/16" wide. Spring length, 17".