Viewing all customer Discussions for:

Other

I accidentally broke the latch off of this door and was wondering if you could tell me the exact model of this latch and what year. It's made by Anderson window

I need to replace the double mortise locking system. Do you carry this?

3 inches high,1 1/4 in wide 1 1/16 offset doors are 1 3/8 I think it was an ACME because the only marking is on the backside and is a capital A inside a circle which I think may be trade mark for Acme.It has a cam device to adjust the height of the door from the floor.

DTC 457 right & left slides. 20-3/8", what is the cost of three sets, for a bathroom vanity, and what is the lead time? Thanks, Jim

I have a ANDERSEN LATCH MECHANISM, PS 3 PANEL latch on two of my sliding doors. Unfortunately, the latch is useless as a slight push on the door (pushing into the house, not along the slider) bypasses the latch entirely. Any suggestions?

Can I buy just the backing plate for the handle? It is cast metal and it cracked and and broke one of the screw attachments.

Have a PGT window with broken balance. Number on the balance is 29-5. LX. CMC 7 What would be the correct replacement unit to order ???

The bar through the ceramic handle snapped. The furniture was purchased in late 1980s.

I am looking for a new lock for my sash controls model# 2303

Looking for a balancer for a Simoton window

looking for Block and Tackle Balance 13 2 BX CMC 7. Thank you.

I'm looking for the plastic clip that secures the tensioning rods for double hung Viking vinyl window.

I think it's going to need a recessed mount in the back. If the mount is on the flat edge of the inside of the sill I think the crank arms will be too high and interfere with the closing of the window. TRUTH HARDWARE 22.29.32.212.

Have broken balances in two windows MI Capital 650 series windows aluminum frames, double pane, argon gas, tilt in bottom sash. Installed in 2003 Pulte Home egret model. I can't find serial number or other information. Thanks for your help.

LOOKING FOR REPLACEMENT FOR THE FELT OR CARPET PATCH LOCATED ON THE DOOR FRAME LOWER CORNER. ITS FUNCTION IS TO STOP AIR LEAK WHERE THE CORNER OF TWO MAGNETIC STRIPS DO NOT FULLY MEET.

need a channel balance for a single hung vinyl window channel length is 28 1/8 inches mark on the channel is 28D channel width is 1/2inch

We have 6 vinyl patio doors that also take the truth 31761 rollers. We cannot remove the door right now, weather too cold. From memmory the roller needed has a mount tab that is extended below the housing. This raises the housing up by 1/4 to 3/8" to line up the adjustment hole. It also raises the w ... (cont.)

DO YOU HAVE A PROFILE CYLINDER WITH A NARROWER BIBLE EXISTING IS 5/16 WIDE

I'm looking for a replacement for this top sash guide. I would appreciate your expertise. Thanks!

I reside in Ontario, Canada, and need a replacement patio door handle. The handle I have is called "Sash Controls Ferndale - 060-1255" I think the measurements between the screws holding it in is 3 15/16 inches. Do you have something like that?