Viewing all customer Discussions for:

Other

Hello, I am looking to replace two door handles. Is this something you can help with?

Another company told me my version is discontinued Do you have anything like this? Thank you.

Do I purchase a Mortise lock for a vertical keyway to replace the lock in the photo?

Only markings appear to be the 17-4 on one side of channel. Unsure as to the specific product due to top and shoe variations. Any help would be appreciated.

Looking for Coil Bance parts shown in photo due to broken spring (and worn parts).

on the hinge it says: US - Patent 6 360 401

I unfortunately don't have all the information you generally seek. But I have an older Pella doorwall. I was unable to find any numbers or markings. My rough meausrements of the roller indicates a length of approximately 2.75", a height of 1.75" and a width (excluding the flanges) of roughly 0.5 ... (cont.)

It would have been great if this part actually came with the screws to install it. Saving 50c has created quite a headache for me, along with a trip to the hardware store. Bought the wrong ones I guess, because #10 32 TPI 5/8in machine screws aren't doing it. Will you please advise what I should b ... (cont.)

Please help me identify which part is the correct replacement for my tilt latch. I would need left hand and right hand. Everything I've looked at seems to be off in 1 or 2 measurements.

Length of metal channel is 26". Width of metal channel is 5/8",on flared side and 1/2" on non flared side. I would like to order 2 please.

I cannot figure out which model I need. I need 1 replacement balance. 1/2 inch wide and 23 inches long.Thank you. John

1/2" wide, imprinted 932

Looking for replacement part number for this operator and the opposite side as well

Please find pictures of alliance window parts that I need part numbers to order.

Looking for a replacement latch to match item in pictures for a storm door 1 5/8" thick. The inside spring is broken and a portion of the housing which encloses the cotter pin is sheared off. The strike is 1" deep.

Not closing properly

Need 4 of these.

No markings found. Window balance ? Pegs in window go onto them and allow them to go up and down and stay open.

The metal channel length is 25.5 inches and has a 25-5 stamp. Need to identify the suitable part

Can you help me find these part for replacement? They are so old and broken