Viewing all customer Discussions for:

Other

need a replacement

I am looking for the new set for replacement. Please review my locks pictures included and advise. If you provide the quotation for this lock set, it is helpful- thank you

These are 1/2 inch wide. What is the correct part number?

Could you please help me find the correct top sash guide. Thank you

plastic insert broke on part connected to the cabinet door. This is an old hinge . Picture you show seems to match in appearance to what I have. Plastic insert at base of frame attachment piece is broken.Would like to purchase 2 complete hinges.

These are on a Florida screened aluminum roofed lanai put up in late 1970s. Each section of windows are four stacking windows. The pins on latches are breaking. Are there replacement corners and latches for these? If you need me to take one out to show you exact dimensions let me know. ... (cont.)

Please see attached photos below - parts needed for repair 0f door. Please reply with this email. Thank you,

I have included the window photo, balancer photo, and serial sticker to the window. We need a replacement balancer. Can you assist thanks.

Need replacement

My chanel balance it's 9/16 , I wonder if this part is the right one .

I believe i purchased these from you before but i purchased the one with the smaller spring ?

Need 2 of them

I have a non tilt channel balance with markings as listed below I need to replace both on the same window 23 9 FW CMC 10

I need to get 2 of these. Length is 34" and width is 1/2". Can't find any stamp or marking, so hope the pictures will help. Window is broken so I could not take pictures of it installed. Thanks!

Doesn't lock need new lock

Not sure.

Plastic mounts for rails of cabinet drawer

They are stamped 2975. They are 30 inches long. They have a metal spring, pulley, and string in the channel

I need part number for this insert. I have previous discussion with disco.

One on each side of top of tilt window. Right and left