Viewing all customer Discussions for:

Other

Can you give me the part number to order? 4610108 6.679.000 On the side of the balance: 27B BSI TJ (with a small TJ). The balance only had one clip.

I need a new door latch. The rest of the door is great however thee door latch is broken where the return spring hooks up. The door has the number 62CVIS036BZ

I need the cap for the pin in the photo.

Broken plastic guide. Can it be replaced.

Hi there- I need to replace a 5.820.170 replacement. The spring or something on the inside is broken. Could you please help me identify which one to replace? Thx!

Hello, I have American Craftsman 50 series 72 in. X 80 in. White vinyl left-hand sliding patio door with blinds. I've missed the key so I need to replace it only the key lock. Can't find the parts anywhere! Thanks in advance for your help.

I need to replace three pairs of window balances. On the front of the frame is BSI 2130.

Please help me with finding the right replacement spring and assembly (if needed) for my window. The spring has 832 stamped on it, as far as I can tell. Thank you!!!

I have a customer whose lower track broke through and the door wheel now gets stuck and requires her to lift the handle in order to get the wheel past the broken part of the track. What is the part number of that piece? And can you point me to instructions on how to replace? Thanks! Door model: ... (cont.)

This balance is 2ft long and half inch thick. It fits inside of our living room window.

I need a replacement for a left Truth entrygard 31538 have found Right handed ones but not left length of the offset attachment arm is 3-3/4" and long arm is 9" with a round wheel at end

All markings have been worn off. It's 12inch long and .5inch wide. This is for our small window bathroom.

Stanley 401 Bedroom sliding mirrored door

Could not see any markings. Considering replacement parts 18-192, 18-008H, 18-064, or 18-115. Please advise if any of these is better or another replacement. Thanks!

Part number on photo, seeking replacement.

Coils have an 8R and 8L also missing retainer. Windows were purchased from a local manufacturer and installer named Kelly Windows.

Hello Swisco! I am searching for a mortise lock that will fit in the slider door from the attached photos. The length from screw hole to screw hole is 3-1/4". The interior slot where the mortise lock rests inside the door has been the issue for me in finding the right lock. I cannot find one that is ... (cont.)

hello - i'm looking for this part for a window, i believe it is a double coil counterbalance for a tilt in window. what would i need to purchase to repair this? thank you. J--

I have what i think is a acorn handle . The lock cyclinder fell out. looks like missing a clip to hold it in. i sent pictures of every thing and lock cyclinder of how it came out. Can i get a clip to hold cyclinder in or parts to fix handle with lock ? Or up grade to newer style handle 3-15/16 in h ... (cont.)

7" x 7/8" strike plate for a screen door.