Viewing all customer Discussions for:

Other

looking for the latch for the storm door in the attached photos. Doo you have one with a 1piece front side??

i purchased your 55-303, and it worked for two out of three of my windows. the third one that it did not work on had the glazing shown in my photo, on the right. i don't see an exact match for this in your catalog, can you source this part?

I am looking to identify a window tilt latch for a Harvey window. The top of the latch length is 2 5/16" and the width is 5/8". It is 3/8" thick. I've also attached a few photos. Any guidance would be great!

Need stainless roller replacement. The tabs broke on these

Tilt window missing slide in pivot window is around 25 years old Can't find any manufacturer name

I am looking to replace this piece from my dresser drawer. The only wording on it is KRENLIN, 2 and PAT PEND. Can you please help me find the correct part?

Do you have these "snap buttons"? I do not think that is what they are actually called though. They install into "inside casement" window screens. They snap behind a lip to hold the screen into the frame. Please advise. Thank you, Jason

Pivot window balance shoe

Hello I have a Pennco window and I missing a few of these screen retainer clips. They sit on the bottom of the window and hold pressure on the bottom of the screen since the screen only lock in by the top with spring loaded push pins. Do you have any suggestions on where can I purchase these from or ... (cont.)

Looking for recommendations for replacing my Pivot locking shoe(s) originally from Penn co. vinyl single sash tilt windows.

The lock on my sliding door needs to be replaced. The handles and the locks latch handle is good I just need the lock mechanism in the door replaced. I have sent a copy from the information tag that is on the door.

Hi do you have track replacements

the link arm of current assembly is 3 3/4 in. The link arm of newer, recently ordered crank has a link arm of 4 7/16 in. which is longer and requires multiple modifications to the brackets on window and sill plate to make work. Hoping there was a model with the shorter link arm

Looking to find this part

2840, 29", but don't know which series.

Hello, having a hard time finding exact replacements for both the inside and outside handles and lock(front door only) on the front door and rear door of my house. Hoping you can guide me on what to purchase to replace both sets without door modifications. Thank you, Mike

Hello, i need a new set of window blancers, from what I have learned that this type is no longer made. Is there any replacment part for this?

Need handle with lock

I have three windows and need replacement springs on both sides.

Coils have a #5.0 and 35 on them. The coil supports are 4 inches tall. I will need numbers for coils, coil supports, pivot shoes and pivots if bar. thank you