Viewing all customer Discussions for:

Other

Looking to id this part, pretty sure it is the snap in glaze beading but just want to be double sure. Thanks

I'm looking for the pair of tilt latch. We bought them years ago from Blaine window & door (SKU WL44C) but now cannot find them. Can you help? Thank you. -Dan

These limited travel possibly shimming screw posts have a slot for adjusting in and out. The wide face at the other end presses against the rough framing. What are they called ,what is their purpose and why are they in the way of replacing the coil shoe and constant force coil springs? ... (cont.)

for vinyl double hung replacement window. 3 1/2 inches Length Overall 3 inches long with 1/2 inch protrusion. see pics 11/16 wide Stamped P30-103

Shaft Length 23 1/2 inches Diameter of tube 5/8 inches white tip coastal environment so non-ferrous parts would be desireable Located in Marina Grande highrise Riviera Beach FL Have three windows with failures so need 6 balance springs

While looking at what you have available , the measurements are just a little different . Do you know what lock this may be from , or who made it ?

Had a company come out and try to replace the wheels and they don't have this old mechanism or wheels this large - 2 or 2-1/2 inches . Didn't see any markings.

Hello - I need to replace several pivot bars in my house - they appear to be 26-377 based on the 8254 printed on the bar, but hoping you can confirm. Additionally, I am not familiar with removing rivets - what method would you recommend to remove these? Finally, from another post I understand th ... (cont.)

I need the entire channel balance replacement part for a viking window. The length is 21". The width of the top part is 1'. Two stamp markings 2030 and BSI...I think. There is also a DL stamp but I do not think that stamp is useful. The windows were purchased in 1999 or 2000. The window does n ... (cont.)

pat4610108....pat6,679,000

I have a full circle casement wood window on an old house that's in a bathroom and the customer wants it to open out. what Type of hinge or closer should I use?

Looking for this part but right-hinged - the matching pair on the other side of the wall is missing, it'll open but then go crooked since it's not anchored on the bottom. I think it's Pella based on the shape of the original crank handles... but no markings on the windows themselves. The bar on th ... (cont.)

springs broken on windows.

Paella between the glass blinds. This part fits through a glass hole at the top window allowing the control strings to exit the blind. It also holds the blind to the top of the window frame. There is a threading screw part and a type of nut part. The screw part is 1/4 inch and fits the hole precisel ... (cont.)

The levers I just bought are a little too thick to slide in can you help me

I purchased the desk and chair from Badcock Home Furniture July 9, 2021. The slides broke 2022 and I cannot use the drawers as designed. The guides were white and wide enough to slide back and forth on a one inch wooden bar.I do not have a picture of the guide.However there is no company name on the ... (cont.)

Hello, I know this particular part is no longer being sold, I have the replacement handle in my cart that I confirmed through this site 88-020. I am wondering if you also sell a replacement/similar style to the bolt that is above the knob

Old sach sliding window hardware

update: my reference # is D7593, I texted a picture to Josh at tech support, I have been on tour site and think what I am searching for is 1 39-094 and 1 39-095. single arm 9 and 3/8 inch long, left and right. please contact me as I am unsure where my request is ? Thanks Tom

Door locks itself. Not sure the brand. Willing to replace the complete assy if I can figure out the door/latch assy manufacturer.