Viewing all customer Discussions for:

Other

The number on the back is 03087.67. Can seem to find these anywhere any help would be greatly appreciated.

Not sure

I'm looking to replace four broken window cranks but don't seem to find the exact match. I've included a picture.

Looking to replace these plastic guides on an aluminum framed sliding glass patio door. Manufacturer unknown but assume are from the late 80's or 90's. The dimension of the inner part of the top door frame is .750" and the narrow is .550". The top track width is 1.450" wide. I don't know the w ... (cont.)

Hello, What is this called I thought it is weather stripping but not sure do you sell this?

Dural central oldpino # 218 Right hand

Hello, I am looking for a sliding door lock that I can lock with a key on the outside and of course a latch on the inside. I have Simonton sliders but not sure what model. The numbers on the door are 40029092020001 and 7WF2WI, not sure if that is correct.

IWe need to replace the'hair' weather seal on our church's front door.

Balance length: 46 Balance stamp: 46-50 Balance color: gray Quantity: 6

Looking to replace 10 years old channel block & tackle window balance 29ds 48l on no tilt high impact windows. What will be the best option? Thank you

It says WinTech Windows & Doors

Looking for window installation bracket for tilt and turn windows

On your YouTube channel there is a video showing a young man removing a 84-094 roller. He calls it by that number. Cannot find that part however on your website. Is it still available?

Do you have anything like attached picture

Our windows are 20 years old. Our roller is 9/16in x 21/8 with pins to hold it in place. See photos. Do you have this or a replacement?

Looking to replace these channel balances. Notable facts 1. one has a marking 24203 and the other has 2420 with the letters b.s.i but appear the same 2. the balance hook is located in the middle part of the sash (as opposed to being at the bottom 3. also need ID for take out clips 4. 25" long ... (cont.)

Need a replacement for this lock. Dimensions from top to bottom screws are about 3 9/16" apart. The circular portion is 1/2" wide by about 3 3/16" end to end. Also curious about the visible lever (that flips up and down on the other side) that triggers the hook lock. Does that come with the lock by ... (cont.)

Size of this lock is exactly matched up with mortise multipoint lock. Which is available on your website.

Balance coils on upper sash are broken and I am seeking replacement parts. Window (0607.jpg) is approximately 2' x 3' and in generally good condition. Part Number shown in 0609.jpg. Broken coil showing attachment tang in 0611.jpg. Thanks, Richard

Nothing to Id this with. Too it to the pros at browns again nothing. Need a few of theseSmall steal ballbearings around the wheelOne wheel