Viewing all customer Discussions for:

Other

20.50 inches20 5it looks like all the pictures you have I need 2 pieces plus I need a few sash? that is on the window not sure what it looks like the broke off that's why it won't lock in Marcos

This picture might be Pella. Another storm door is. Can't find the perfect size. About 9 1/2 inches top to bottom and 1 1/4 across.

Looking for this tilt window latch . Screw hole spacing is 1 1/4 inch

15" metal rail only, not including plastic. Has stamped A1420. Hoping you have the replacement part. Thank you

I have 2 dressers with a combined 3 drawers that will not fully close. (See attached picture for example). All drawers come to a stop and won't slide any further before they are flush with the other drawers. On some drawers, the plastic slide (Kenlin Case Runner) on the metal piece that is in the ... (cont.)

The wheel diameter is 1 1/4 The height is 1 1/8 The width is 5/8 This was off of a older mobile home. I don't know enough about them to know which one I can use as a replacement because I can't find the exact match to this. Any help is greatly appreciated

A plastic piece maybe called "tie bar guide" ? Truth Hardware

It's the front wheel assy by the latch of the door.

Marvin casement window, approx 56" tall by 21" wide, hinged on right, installed in early 1996. Window cranks in and out, but the locking mechanism is broken. It's a multipoint locking system with two keepers and a single locking lever. The two keepers are stamped "31787" and installed 39 3/4" apa ... (cont.)

I'm not positive what replacement parts are required. The window brand is unknown. Kindly advise if additional information is necessary. Than you for your assistance.

Do you have a replacement part for this. Complete unit needed. Thanks

Please let me know if you have these parts for both sides and any other parts I might be missing. Thanks

I have MW double hung tilt windows with broken balance tubes. I believe they are the same as the a ones above. I'm hoping the Series 795 channel balance are what i need. My old tubs have a length of 23 inches. The shoe is 1 1/4 wide X 1 1/2 high, the sash weight is 14.5 LBS. I have provided pic of ... (cont.)

Please help me find this part no. or the replacement for this. Thank you Bha

Hi there, The metal part measures 27'' long and ~1/2'' wide. The bottom fitting measures 1-3/32'', I think S350 will be an option, I am just wondering about the difference between S350 and S385. Thank you!

Looking for a white vinyl glazing bead as in photo.

The attached photos are the parts I need replaced but in white. Can you let me know which replacement parts I should purchase. I will need 2 of each. The crank has no. 45054 the lock has no. 30838 I look forward to hearing from you. Thanks!

These both came from the same window. They are 29 inches in length and 3/8 inch diameter. They are attached at the top with a simple screw and an attached clip at the bottom. The symbols on them are very faded, but look to read out as "GC B 1375". This could be incorrect however. ... (cont.)

Looking for this 9"casement operator.

I am looking to replace a Truth casement window latch - part #40902L (2 photos enclosed) Hopefully you have a replacement option for this. I send two images of the bent sash lock part. (perhaps I should simply re-bend, but I am nervous about strength and failure.