Viewing all customer Discussions for:

Other

Looking for repair 1600-17. E20 9#27 2-85

HiI live in NM and the seal on some of my windows needs replacing ( slightly over 100 feet). Attached please find pictures of existing seal. Hoping you can help.Barry

Thank you.

Missing pin for 3" hinge for Pella screen door. Will accept a whole new hinge set if possible. Your attention appreciated,

I would like to identify my channels. I am sending pictures.

We live in older mobile home with storm windows on sunroom. Looking for latch's. I have attached a picture. Thank you so much

Length of balance is 27 1/16", not sure who made the windows, they were installed when the house was built in 1996.I need four of these, thank you! George

This is for the left side of the window. The balance popped out and I guess the spring sprung up. Will you be able to help me match what I need? Thank you

holds the window to the balance

Hi Swisco team I have an old channel balance from aluminum non-tilt windows with the following specifications: L : 33 in W : ? in Stamp : 3230 Top vinyl : see photos Bottom vinyl : see photos Would you kindly help me find the right match ? Thank you very much. Update-Customer re-measured an ... (cont.)

Hello. The stamp on the balance says: 26-6 HK5 CMC 43. Can you help me find a replacement, please? Thank you for your time.

I need a crank handle for my casement window and a closer for a storm door. A Swisco rep showed me one closer but it didn't look like mine. His had a hole at the end but mine doesn't Please see the pictures. Do you have this for me?

There are no markings or numbers on this part. I have weighed the window sash and it is 20 lbs

Need this replacement part Delmas entry guard assembly 40754

Need help figuring ot the missing latch piece that goes to the latch

When identified, can these be expidited?

Need to match tilt window locks in pictures and match the balancer style and shoe at the bottom of the balancer.

Hello,I have some pile weatherstripping to replace on my sliding window, I wanted some help to identify the correct product.The width of the base seems to be 2/16th of an inch and the height of the pile seems to be 3/16th of an inch.Do you have any replacement for this kind?Thanks for your help.Rega ... (cont.)

Can you please give me a model number for this piece

Looking for a DCS Screen Roller 1992-12/2004