Viewing all customer Discussions for:

Other

Can you help me figure out which brand/part this is? One of my locks broke, and I can't figure out what to replace it with. I don't need the piece it locks into, just the gray licking mechanism and the cover

Width 11/16" heigth 1" wheel 1 1/2"

Metal length is 30 inches. The marking is 29 3 BV CMC 7.

I have a coil balance on my final window that has failed. I need help in identifying and buying a replacement coil balance. There are no numbers or name on the window to tell me the manufacturer so I’m hoping the pictures I’ve included will help, there is also no easy way to uninstall an ... (cont.)

Approximately 2-5/8" long × 11/16" wide × 7/16" thick. Type: Slide-in / mortise window tilt latch Needed: Left and right pair

The spring snapped on my window coil balance, I'm looking for a replacement part

2420 BSI VF

This part goes on back of drawer that enable the drawer to slide into a wooden track

Hi! I got a loose crank and looking for the replacement. My house was built in 1987 so the model must be old. Would be much appreciated in if you know the model from the picture. I believe it is an Anderson window. best regards, Bill

I bought a sliding glass door about 6 years ago from Home Depot and the latch is broken , I have been unable to find a replacement for it , faceplate is around 11 3/4 total length

Some are beige or stone. One is white. Don't know the window brand or even if the white is the same brand as the stone. It is in an out building on the same property.

Need new lock with a curved sash to fit into existing receptacle in photo 2. Holes for lock screed are 2 1/4 inches. Existing sash gas number 2213 imprinted with handle having 2214 imprinted.

I need to replace the outside knob and was advised you have something that might work with the existing set up

Looking for replacement to install.

I don't know the size I need or exact part. Dimensions are 16 mm by 67 mm

This is for a single panel storm door. The retainer strips on both sides need replacing. I'm trying to find out how to order the correct vinyl stripping. Thank you.

I am looking for this replacement. I need two of this item. It is for a non tilt window. House was build in 2002. Thank you.

The channel balance is 24" length 1/2" width Stamp reads 2340n2 The shoe size is 1 1/8 " . Would the s385 be the correct choice?

It says Tilt-Safe. Place for your finger and two screw holes. It is a latch for windows that tilt out for cleaning.

I need one Post. But I wouldn't mind buying all three different sizes. -2 inches long 1 inch high as shown in the picture. Can you let me know if you have one of each of your sizes or the exact one. I wouldn't mind buying 4 if it was the exact post