Viewing all customer Discussions for:

Other

I need to replace 2 balancers for 1 window as shown in photos. Printed on metal section is: 28 4 AO Caldwell The metal section is 28 7/8" and measures 0.595" deep, 0.547" wide. The weight is 27.5 lbs.

We have a Unigrass 6600 system for the slide-out shelving in our kitchen cabinets. It has rear sockets that are recessed into the back of the cabinet. I have the bottom support break off on a couple of the rear sockets, dropping the slide. One I was able to overcome by taking one that was not use ... (cont.)

Need to buy the handle

cabinet mounting surface is 3/4" will need two hinges.

I need to order 4 of them. For the windows they don't till they slide up

I am looking for replacement pivot bars for the locking shoe type in the photos. How would I determine what I would need thanks

Please help me select the correct balance replacement bar. Thank you

Looking for a soft close replacement need 4 i also need (4) 42-353 thank you

The previous homeowner removed the lock. I know I need a double point mortise lock and a new thumb latch but I'm stuck on the keeper. The predrilled holes don't line up with anything. What am I'm missing? The holes are 4 inches apart on one side and 1 3/8 on the other. The handle has 4 15/16 inch sc ... (cont.)

I am looking for a left and right folding handle for an operator that has 40754 stamped on the bar.

Hi! I need to replace the mechanism to open the window and the track. Both are broken. The screw holes are also stripped in the window itself. The part numbers I can see say Truth 30905, but I can see a number on the track. Could you please help me figure out what I need in order to replace this? T ... (cont.)

Door handle certandeed

Can you help me figure out which brand/part this is? One of my locks broke, and I can't figure out what to replace it with. I don't need the piece it locks into, just the gray licking mechanism and the cover

Width 11/16" heigth 1" wheel 1 1/2"

Metal length is 30 inches. The marking is 29 3 BV CMC 7.

I have a coil balance on my final window that has failed. I need help in identifying and buying a replacement coil balance. There are no numbers or name on the window to tell me the manufacturer so I’m hoping the pictures I’ve included will help, there is also no easy way to uninstall an ... (cont.)

Approximately 2-5/8" long × 11/16" wide × 7/16" thick. Type: Slide-in / mortise window tilt latch Needed: Left and right pair

The spring snapped on my window coil balance, I'm looking for a replacement part

2420 BSI VF