Viewing all customer Discussions for:

Other

Shower Door Rollers/Runners/Spares/Grooved Wheels for rv round shower

What is the part

Kindly assist with ID of my Channel Bal, I think it is 390?Channel Bal Specs/Info: Numbers ShownStamped on Balancer: 27CLength: 27 15/16 In (or 28 In)Width: 5/8 In (or 9/16, Aka 1/2 In)Foot Dept: 1 1/8 In?Note: I was not sure how to measure this, see picsWindow Brand: Alenco (Condo Built in 1 ... (cont.)

Can you help me with this? Ray Ciccolilli

Hello, I'm looking to replace my sliding glass door handle, (both sides). I hope this picture will help!

The label on the item is 86 14-4 CAS CMC 7. The channel is 15" long

the only numbers on the balance are 24 3.RNBS1 TH the metal measure 263/4 inches there is no clip to hook cord to? need to order two balances for my window sash. want to order the correct balance to fix my window

Clip on bottom. Need crank.

reliabilt replacement #0219942

I have attached pictures of the tilt latches and spring assemblies for a window i have. I also attached picture of the id tag from the window as well. I need 2 latches, springs and the plastic holder for both sides as well as the pieces the springs attach to at the bottom. Also need pieces to go on ... (cont.)

It goes on the side of the sliding glass door at the bottom and kind of looks like a little brush to keep the tracks clean

This locking mechanism on my sliding door is no longer latching, I think this door was shut with the lock engaged a few too many times. I'm having trouble figuring out which parts to buy to make this swap - any advice would be appreciated.

Greetings, I was referred to you by Milgard hoping to identify and order the parts needed to get these L and R windows attached and cranking again. Any help would be appreciated. Thank you!Jason

Do you have a bubble seal that could replace the gasket on the Truth Hardware crank windows. It looks like 25ft Bubble Seal, 3/16" x 11/32" Product Code: 58-135 matches the best in terms of measurements (mine is 5/16" diameter and the widest part of the "t" is 3/16"). The bottom of the seal I have i ... (cont.)

Hi there!I was hoping for some assistance identifying this balcony door handle. Photos are attached.Markings say: Allen Stevens Corp 6768I want to avoid taking it apart unless absolutely necessary to identify replacement parts.Thank you!

Hi,I'm looking for the part that is pictured below lastlyInside the sash providing the lifting action of the bottom portion of a double hung window.Both pieces of another window were brokenThe make of the window says radiance on the two locks to latch the window.The plate screwed into the sash holds ... (cont.)

Andersen window lock bronze right handed 00109-NEW-R067

Just need the picture, I have the shaft and handle, may need any hardware needed.

I need to replace the broken part to make the window function. Window was installed in 2013.

Hi To whom it may concern. I am looking for some replacement screw plugs for our sliding glass door. One plug would go in the door handle (see picture attached). The larger plug goes at the base of the sliding door (see picture attached). I assume the smaller one is 3/8" on the interior side and th ... (cont.)