Viewing all customer Discussions for:

Other

I have attached the photos. 7/8" long 5/16" depth. Will 95-218 and 95-262 fit for this replacement. Thanks

Window will not stay up

I have a Sd-r50-1816x2426(72x96) This patio door was already installed when we purchased a home. It never had a mortise lock. I've purchased two different locks to try and install them. The opening on the door is only 3 1/4 inches. None of the locks will fit inside. Do you have a spacing template o ... (cont.)

Hello, When we moved into our home and had the floors done. The installers lost the hardware for one closet door. Fast forward 3 years later I have been searching for the parts. I hoping someone may be able to make my dream come true and find the right parts. In one of the photos I share curren ... (cont.)

The balances needs replacing because when raised the window will not stay up. I measured from top to middle of window 22 inches. The window length is 46 inches long. This is a non tilt window. What type and size balances do I need. Picture posted of balance in window

Hi, I live in Chico CA. I have 5 windows. I would make the order but I want make sure I am purchasing the right product. Best,

please help me with identifying a replacement for my window balance. It has 24 B B.S.I. on it and that's it. The metal part is 25" long

Hello, just wondering if you have a source for us to be able to replace these types of locks in our house. The windows are approximately 1993/4 build. Thanks Lyndon

1-1/4 diameter metal concave wheel. Assembly width is about 9/16" wide (excluding dimples). Frame length is about 2-1/4" long. Door frame inside width is about 7/8" Door frame depth is about 1-5/8" I am thinking that SWISCO model 81-077 is a close match? The mount tab can be turned? ... (cont.)

Hi, I'm trying to find a window balance. It has the number 1650 on the back. Would you be able to help me find it? Thanks so much!

The top of the bar (looking down from how it is seated in the window) has an R stamped on it, which I'm guessing is for "right." On the bottom is a 3. This one is obviously bent and I'm hunting for a replacement. I can't find the brand of the windows.

Looking for door rollers for a vinyl patio door from VIPLEX circa 2005. Thank You

old kitchen cabinet flush mount

I'm looking for something to replace an original Pella door strike plate from 1991.

A new locking handle that fits our window but the curved up part that catches the lock keeper will not reach. Is there any way to adjust it so it will lock?

I have an American Craftsman Series 8500, double hung, installed in 2005.It appears that the lower sash coil spring got damaged and doesn't function.I have not yet taken the Pivot Shoe and Coil Spring out to get exact measurements, but it appears to be very similar to your Coil Housing Pivot 15-087 ... (cont.)

I have a Pella Sliding glass door. Looking to buy a new door to jam seal.

Hello, can you tell me based on the photos if parts 26-419 and 26-420 are the correct parts to match my latches?Thank you,Joe

I am looking for this tilt latch.

The door these rollers came out of is an older glass sliding door. Unfortunately, there were no wheels in them so I can't provide any wheel measurement. The length is 2 1/4 inches, the width is 1/2 inch, and the height is 7/8 inch. Any help will be greatly appreciated.